Closure to “Discussion of ‘Tip Leakage Flow in Axial Compressors’” (1991, ASME J. Turbomach., 113, p. 259)
نویسندگان
چکیده
منابع مشابه
Closure to “Discussion of ‘Factors of Safety for Richardson Extrapolation’ ” (2011, ASME J. Fluids Eng., 133, p. 115501)
The Technical Brief by Roache [1] presents ten items of discussion of our factor of safety (FS) method for solution verification [2]. Our responses are listed below item-by-item using the same numbering as Roache. The nomenclature mostly follows our own and not Roache’s such as pRE for the order of accuracy calculated using the Richardson Extrapolation as opposed to the observed order of conver...
متن کاملEffects of Different Turbulence Models in Simulation of Unsteady Tip Leakage Flow in Axial Compressor Rotor Blades Row
Characteristics of rotor blade tip clearance flow in axial compressors can significantly affect their performance and stable operation. It may also increase blade vibrations and cause detrimental noises. Therefore, this paper is contributed to investigate tip leakage flow in a low speed isolated axial compressor rotor blades row. Simulations are carried out on near-stall condition, which is val...
متن کاملRotating Stall in Axial Flow Compressors
Ever increasing demand of higher pressure ratio of aero-engine compressors has always been hindered by two distinct aerodynamic instabilities. The first known as surge is; large one dimensional periodic mass flow fluctuation through the compressor, which involves the entire pumping system including compressor, ducting, plenum and throttle. The second is the rotating stall which can be character...
متن کاملRotating stall control for axial flow compressors
Plus BROWSE SEARCH IEEE XPLORE GUIDE SUPPORT View TOC Rotating stall control for axial flow compressors Belta, C. Guoxiang Gu Sparks, A. Banda, S. Dept. of Electr. & Comput. Eng., Louisiana State Univ., Baton Rouge, LA; This paper appears in: Decision and Control, 1998. Proceedings of the 37th IEEE Conference on Publication Date: 1998 Volume: 3, On page(s): 2557-2562 vol.3 Meeting Date: 12/16/1...
متن کاملNumerical and Experimental Investigations of Flow Control in Axial Compressors
T he increase of the thrust-to-weight ratio of modern gas-turbine engines results in higher loads and a reduced number of blades and stages for the compressor. The designer must ensure the acceptable performance of each compressor stage (efficiency and stable operating range) and control the rising risk of blade boundary layer separation. This can be obtained using passive or active control dev...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Turbomachinery
سال: 1991
ISSN: 0889-504X,1528-8900
DOI: 10.1115/1.2929097