CMOS-integrated Sensor chip for in-plane and out-of-plane shear stress
نویسندگان
چکیده
منابع مشابه
3D Out-of-Plane Flow Sensor Array with Integrated Circuits
Micromachined resistors are thermal transducers that can be used to measure air and water flow rate. For the thermal resistor to function as a flow sensor, the electrical resistivity must be a strong function of temperature it must be sufficiently thermally isolated from the supports and substrate. The thermal resistor can be made of a metal or doped semiconductor and can thermally isolated by ...
متن کاملOut-of-Plane Cmos Compatible Magnetometers
Three-dimensional MEMS magnetometers with use of residual stresses in thin multilayers cantilevers are presented. Half-loop cantilevers based on Lorentz-force deflection convert magnetic flux in V ∆ changes, thanks to piezoresistive transducers mounted in Wheatstone bridge. Magnetic field in the order of 10 Gauss was measured with a sensitivity of 0.015 mV/Gauss. A Finite Element Model of the d...
متن کاملImpact of Integration on Straining Modes and Shear-Locking for Plane Stress Finite Elements
Stiffness matrix of the four-node quadrilateral plane stress element is decomposed into normal and shear components. A computer program is developed to obtain the straining modes using adequate and reduced integration. Then a solution for the problem of mixing straining modes is found. Accuracy of the computer program is validated by a closed-form stiffness matrix, derived for the plane rectang...
متن کاملCompound Strip Method for Plane Stress
The compound strip method (CSM) for plates is an expansion of the finite strip method (FSM) and was developed to incorporate the effects of the support elements in the analysis of linear elastic plate systems. In this paper the CSM is further expanded to analyze structures such as stiffened plates under loads in the plane of the plate or the so called plane-stress condition. Examples of these t...
متن کاملIn-Plane and out of Plane Free Vibration of U-Shaped AFM Probes Based on the Nonlocal Elasticity
Atomic force microscope (AFM) has been developed at first for topography imaging; in addition, it is used for characterization of mechanical properties. Most researches have been primarily focused on rectangular single-beam probes to make vibration models simple. Recently, the U-shaped AFM probe is employed to determine sample elastic properties and has been developed to heat samples locally. I...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2010
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2010.09.368