CO Sensitive Pt/SnO2Diode Type Gas Sensor
نویسندگان
چکیده
منابع مشابه
ZnO Nanowires/Nanobelts Structured CO Gas Sensor
Zinc oxide nanowires/nanobelts thin films were prepared by thermal evaporation deposition of Zn on two different kinds of substrates, namely Cr-glass and Cr-<100> n-type Si. ZnO nanostructured based COgas sensing thin films were formed, and the morphologies of these films were investigated by scanning electron microscopy (SEM). The sensing response of the films toward CO gas at operating temper...
متن کاملSnO2 Highly Sensitive CO Gas Sensor Based on Quasi-Molecular-Imprinting Mechanism Design
Response of highly sensitive SnO2 semiconductor carbon monoxide (CO) gas sensors based on target gas CO quasi-molecular-imprinting mechanism design is investigated with gas concentrations varied from 50 to 3000 ppm. SnO2 nanoparticles prepared via hydrothermal method and gas sensor film devices SC (exposed to the target gas CO for 12 h after the suspension coating of SnO2 film to be fully dried...
متن کاملDesign and Simulation of a New Highly Sensitive Gas Sensor Based on Negative Refraction Photonic Crystal
In this paper, design and simulation of a new highly sensitive gas sensor based on a hybrid photonic crystal (PC) structure, containing negative and positive refractive index sections, is presented. It has been shown that using a PC with negative refraction in the first section, the transmitted power is concentrated on the entrance of the sensing channel, and the transmission of the proposed se...
متن کاملThe Effects of Nano In2O3 and ZnO on the CO Gas Detection of the SnO2 Sensor
The pellet-type SnO2 sensor was synthesized by the solid state method and the effects of additives such as nano ZnO (1-12 mol %) and nano In2O3 (1-10 mol %) on the CO gas sensitivity of sensor were investigated. The optimum sintering temperature was chosen 800°C because of the porosity content of the samples. The phase analysis and microstructure of the samples were studied by x-ray diffraction...
متن کاملthe effects of nano in2o3 and zno on the co gas detection of the sno2 sensor
the pellet-type sno2 sensor was synthesized by the solid state method and the effects of additives such as nano zno (1-12 mol %) and nano in2o3 (1-10 mol %) on the co gas sensitivity of sensor were investigated. the optimum sintering temperature was chosen 800°c because of the porosity content of the samples. the phase analysis and microstructure of the samples were studied by x-ray diffraction...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chemistry Letters
سال: 1987
ISSN: 0366-7022,1348-0715
DOI: 10.1246/cl.1987.2001