Coated carbide.
نویسندگان
چکیده
منابع مشابه
Control of eta carbide formation in tungsten carbide powders sputter-coated with (Fe/Ni/Cr)
Composite powders of tungsten carbide with variable coating contents of Fe/Ni/Cr based alloys (1–15 wt.%) were prepared by sputtering. The coated powders have revealed a good performance to shape-forming and sintering. However, the presence of nanocrystalline coatings could enhance the formation of a brittle phase during sintering, named g-phase, (M,W)6C. To investigate this effect, the powders...
متن کاملCheck Tic-coated Tungsten Carbide Tool Wear in Machining Steel
In industrial production systems, including the most important factors in the economic field machining operations, reduce tool wear due to abrasive nature of the phenomenon on many factors, including temperature Lathe tool, influences, machining conditions (cutting speed, speed losses, forcing to rebuild parts of the manufacturing tolerances disassemble tool wear is caused by the phenomenon, as...
متن کاملSingle Point Diamond Turning of CVD coated Silicon Carbide
Scratching experiments, using diamond styli and single point diamond tools, were performed to simulate Single Point Diamond Turning (SPDT). The results of these experiments were used to determine if a ductile response is possible, and then to determine the critical depth of cut or penetration depth for the ductile to brittle transition (DBT). The depths of the scratches produced at different lo...
متن کاملAtomic Force Microscopy (AFM)Topographical Surface Characterization of Multilayer-Coated and Uncoated Carbide Inserts
In recent years, scanning probe atomic force microscopy SPM AFM has gained acceptance over a wide spectrum of research and science applications. Most fields focuses on physical, chemical, biological while less attention is devoted to manufacturing and machining aspects. The purpose of the current study is to assess the possible implementation of the SPM AFM features and its NanoScope software i...
متن کاملThe vacuum hot pressing behavior of silicon carbide fibers coated with nanocrystalline Ti–6Al–4V
The vacuum hot pressing (VHP) of silicon carbide monofilaments coated with nanocrystalline Ti–6Al–4V has been studied. During consolidation, very high densification rates were observed, even at temperatures and pressures well below those normally used for processing conventional Ti–6Al–4V. From the cross-sections of partially consolidated specimens, the evolution of coated fiber–fiber contacts ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1986
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.52.1508