COLD ROLLING AND ANNEALING OF SAFTY RAZOR BLADE STEEL
نویسندگان
چکیده
منابع مشابه
Processing of Fine-Grained DP300/600 Dual Phase Steel from St12 Structural Steel by the Thermo-Mechanical Processing of Cold Rolling and Intercritical Annealing
The effect of microstructural refinement and intercritical annealing on the mechanical properties and work-hardening response of a low carbon St12 steel was studied. It was revealed that intercritical annealing of the ferritic-pearlitic sheet results in the formation of a coarse-grained DP microstructure with discrete martensite islands normally formed in place of pearlitic colonies, which resu...
متن کاملConservative management of razor blade ingestion
A 30-year-old woman presented to the emergency department complaining of abdominal discomfort. An abdominal radiograph was done, revealing ten rectangular razor blades measuring 5 × 2 cm. The patient was taken to the operating room and a flexible esophago-gastroduodenoscopy was performed. Attempts at retrieval, using both a gastric overtube and an inverted hood, were unsuccessful due to the sha...
متن کاملRazor blade section in cataract surgery.
There are many techniques of cataract extraction and many types of cataract knives have been devised to facilitate an ideal section. Ultrasharp diamond knives were introduced by Durham and Luntz (I968). Sharpness is essential whether the von Graefe knife, the keratome, or corneal scissors are used, and for this reason disposable cataract knives, keratomes, and Bard Parker blades are widely used...
متن کاملStrain-Induced Martensite Transformation Simulations during Cold Rolling of AISI 301 Austenitic Stainless Steel
Austenite is a semi-stable phase in most stainless steels that deforms to martensite under Md30 and forms martensitetype ά and ε due to the deformation in the steels. Since the distribution of strain induced martensite plays animportant role in achieving desired properties, the main objective of the present work is to model martensitedistribution of ά during cold rolling using...
متن کاملKinetics of Austenite Recrystallization during the Annealing of Cold-rolled Fe-Mn-Al-C Steel
In the current study, the recrystallization behavior of 75% cold-rolled Fe-22Mn-10Al-1.4C steel during annealing at 750, 770, 790, 810, and 830°C was studied. X-ray diffraction patterns and optical microscopy were used to characterize microstructures. The Vickers Micro-hardness test was used to characterize recrystallization kinetics during annealing. Johnson-Mehl-Avrami-Kolmogorov (JMAK) model...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1952
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1915.38.3_159