COLLAPSE BEHAVIOR OF DYNAMICALLY CRASHED HEXAGONAL THIN WALLED STRUCTURES WITH MULTI-CELL CROSS-SECTION GEOMETRY
نویسندگان
چکیده
منابع مشابه
Experimental and Numerical Studies on the Characteristics of Simple and Multi-cell Shapes of Quasi-hemisphere Thin-walled Structures
Thin-walled energy absorbers are used to reduce accident induced damages. In this study, thin-walled stainless steel structures in quasi-hemisphere geometry were subjected under quasi-static loading with Santam 150KN apparatus. Experimental results were compared with results of numerical simulations by LS-DYNA and it was shown that there is a good agreement between experimental and numerical r...
متن کاملThin-walled beams: the case of the rectangular cross-section
In this paper we present an asymptotic analysis of the three-dimensional problem for a thin linearly elastic cantilever Ωε = ωε × (0, l) with rectangular cross-section ωε of sides ε and ε 2, as ε goes to zero. Under suitable assumptions on the given loads, we show that the threedimensional problem converges in a variational sense to the classical one-dimensional model for extension, flexure and...
متن کاملThin-Walled Structures
Experimentally determined natural frequencies and modes shapes are presented for an elastically point-supported isotropic plate with attached masses under impulsive loading. These results are compared to frequencies and to modes shapes determined from the Rayleigh–Ritz method and a finite element analysis using COMSOL. Accelerometers mounted at three locations on the plate, provide input for ME...
متن کاملThin-Walled Structures
This paper presents a procedure to determine an element-length dependent strain and stress relation until fracture that is suitable for implementation in finite element models. This material relation is obtained experimentally with an optical measuring system. The strain until fracture is calculated from the measured surface displacements. The stress is derived from the measured force and the c...
متن کاملAnalysis of Thin-Walled Structures Using Torsional-Bending Elements
In this paper a new element for analysis of thin-walled structures is presented, and the effects of secondary shear stresses on longitudinal displacements are examined. Since the Interpolation Functions are based on non-uniform torsional differential equations, the analysis of stiffness matrix is facilitated. Therefore, its ability to produce accurate results with the least number of elements i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Engineering Studies and Research
سال: 2017
ISSN: 2068-7559
DOI: 10.29081/jesr.v20i2.70