Colloidal Processing for Fine Particles of Al2O3-15vol% ZrO2 System.
نویسندگان
چکیده
منابع مشابه
simulation and design of electronic processing circuit for restaurants e-procurement system
the poor orientation of the restaurants toward the information technology has yet many unsolved issues in regards to the customers. one of these problems which lead the appeal list of later, and have a negative impact on the prestige of the restaurant is the case when the later does not respond on time to the customers’ needs, and which causes their dissatisfaction. this issue is really sensiti...
15 صفحه اولFine Particles Processing
It is vell known that fines and ultrafines can cause severe problems in mining and mineral processina. The decrease in the grade of ore combined with the arowinS demand for aineral products baa led to the minina and milling of increasing tOQnage or ore. Cl08ely linked with the problem of reduction in the grade of ore is. the more serious problem of the decrease in libration size. A direct cODsq...
متن کاملFe3O4@ZrO2-SO3H Nano-particles for esterification of carboxylic acids
In this work preparation of sulfonic acid functionalized magnetite encapsulated zirconia (Fe3O4@ZrO2-SO3H) has been reported. Structural, chemical, and magnetic properties of the magnetically supported catalyst have also been investigated by Fourier transform infrared (FT-IR) spectroscopy, wide angle X-ray diffraction spectroscopy (WXRD), thermal gravimetric analysis (TGA), energy dispersive X-...
متن کاملStability diagram for dense suspensions of model colloidal Al2O3 particles in shear flow.
In Al2O3 suspensions, depending on the experimental conditions, very different microstructures can be found, comprising fluidlike suspensions, a repulsive structure, and a clustered microstructure. For technical processing in ceramics, the knowledge of the microstructure is of importance, since it essentially determines the stability of a workpiece to be produced. To enlighten this topic, we in...
متن کاملAl2O3/ZrO2/Y3Al5O12 Composites: A High-Temperature Mechanical Characterization
An Al2O3/5 vol%·ZrO2/5 vol%·Y3Al5O12 (YAG) tri-phase composite was manufactured by surface modification of an alumina powder with inorganic precursors of the second phases. The bulk materials were produced by die-pressing and pressureless sintering at 1500 °C, obtaining fully dense, homogenous samples, with ultra-fine ZrO2 and YAG grains dispersed in a sub-micronic alumina matrix. The high temp...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1997
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.44.356