Combined Electro-Fenton and Anodic Oxidation Processes at a Sub-Stoichiometric Titanium Oxide (Ti4O7) Ceramic Electrode for the Degradation of Tetracycline in Water

نویسندگان

چکیده

The mineralization of tetracycline by electrochemical advanced oxidation processes (EAOPs) as well the study toxicity its intermediates and degradation products are presented. Electro-Fenton (EF), anodic (AO), electro-Fenton coupled with (EF/AO) were used to degrade on carbon felt (cathode) a sub-stoichiometric titanium oxide (Ti4O7) layer deposited Ti (anode). As compared EF AO, EF/AO system resulted in highest pollutant removal efficiencies: total organic was 69 ± 1% 68 1%, at 20 ppm 50 initial concentration tetracycline, respectively. effect electrolysis current efficiency, energy consumption, solution investigated for tetracycline. process using Ti4O7 anode CF cathode provides low high efficiency caused production hydroxyl radicals both surface non-active electrode cathodic felt. Complete observed from HPLC data after 30 min optimized conditions 120 mA 210 concentrations. Degradation elucidated, measured luminescence Microtox® bacteria test.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Electrochemical degradation of RB-5 dye by anodic oxidation, electro-Fenton and by combining anodic oxidation-electro-Fenton in a filter-press flow cell

This is a PDF file of an unedited manuscript that has been accepted for publication. As a service to our customers we are providing this early version of the manuscript. The manuscript will undergo copyediting, typesetting, and review of the resulting proof before it is published in its final form. Please note that during the production process errors may be discovered which could affect the co...

متن کامل

treatment of waste sludge: a comparison between anodic oxidation and electro-fenton processes

background: electrochemical methods, as one of the advanced oxidation processes (aops), have recently been applied to remove different contaminants from water and wastewater. this study compares the performance of anodic oxidation (ao) and electro-fenton (ef) methods on waste sludge treatment. methods: this experimental study was performed on real sludge and the effect of operating parameters s...

متن کامل

Treatment of waste sludge: a comparison between anodic oxidation and electro-Fenton processes.

BACKGROUND Electrochemical methods, as one of the advanced oxidation processes (AOPs), have recently been applied to remove different contaminants from water and wastewater. This study compares the performance of anodic oxidation (AO) and electro-Fenton (EF) methods on waste sludge treatment. METHODS This experimental study was performed on real sludge and the effect of operating parameters s...

متن کامل

Anodic oxidation of Methidation at boron-doped diamond electrode and degradation mechanism

This paper presents the study of the electrochemical oxidation of the insecticide Methidathion organophosphorous pesticide, using a boron-doped diamond (BDD) anode. The influence of current density, sodium chloride concentration, temperature and initial Methidathion concentration on the rate of COD abatement has been followed. The electrolyses were performed by using a solution composed of an e...

متن کامل

Titanium oxide nanotube arrays prepared by anodic oxidation

Titanium oxide nanotubes were fabricated by anodic oxidation of a pure titanium sheet in an aqueous solution containing 0.5 to 3.5 wt% hydrofluoric acid. These tubes are well aligned and organized into high-density uniform arrays. While the tops of the tubes are open, the bottoms of the tubes are closed, forming a barrier layer structure similar to that of porous alumina. The average tube diame...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Water

سال: 2021

ISSN: ['2073-4441']

DOI: https://doi.org/10.3390/w13192772