Combined Removal of n-heptane and CO using Plasma-catalytic Process
نویسندگان
چکیده
منابع مشابه
Industrial application of catalytic systems for n-heptane isomerization.
The ideal gasoline must have a high pump octane number, in the 86 to 94 range, and a low environmental impact. Alkanes, as a family, have much lower photochemical reactivities than aromatics or olefins, but only the highly branched alkanes have adequate octane numbers. The purpose of this work is to examine the possibilities of extending the technological alternative of paraffin isomerization t...
متن کاملCATALYTIC REFORMING OF n-HEPTANE ON PLATINUM-TUNGSTEN SUPPORTED ON GAMMA-ALUMINA
The mono-metallic and bi-metallic catalysts have been prepared by impregnating with solutions containing a compound of H2PtCl6,WO3 and 1ml HCl (0.1 mol). It should be noted that the catalysts’ activity and selectivity have been determined under these conditions : 450-5000C ,and 15-25atm by H2. For converting n-heptane , the molar ratio H2/C7H16 is 5 , and LHSV is 1.5ml/h. It has been proved tha...
متن کاملDetermination of Activity and Selectivity of n-Heptane by Reforming Catalytic Pt-V Supported on gamma-Alumina
Bimetallic Pt-V supported by Gamma-alumina is used to observe the changes of nheptanewhen passed over this catalyst. The Pt concentration was kept constant at0.1wt% while the concentration of the vanadium was 0.5wt%. The activity andselectivity of catalyst have been determined under conditions at 450-500 degreescentigrade and 15-30 attn. The experimental results show that the addition of second...
متن کاملCATALYTIC REFORMING OF n-HEPTANE ON PLATINUMNIOBIUM SUPPORTED ON GAMMA-ALUMINA
The series of mono-metallic and bi-metallic catalysts have been prepared by impregnatingwith solutions containing compound of H2PtC15,NbC15 and lml HC1 (0.1 mol). The activityand selectivity of the catalysts have been determined under conditions at 450-500°C, 15-30atm. Molar ratio H2/C7H16=5 and VVH=1.5/h for converting n-heptane. Under theseexperimental conditions it has been established that ...
متن کاملCatalytic Reforming of n-Heptane on Platimum - Rhenium Supported on Gamma-Alumina
Catalyitic reforming is one of the refinery processes in catalyst conversion that results to anincreases in octane number of naphtan which leads to production of gasoline with higher octanenumber. Hydrocarbons with high octan number that are produced in reforming process are as;aromatics, paraffins, isomers and etc.Not only Aromatics are used as fuel for motors but they are also useful in petro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korean Institute of Gas
سال: 2016
ISSN: 1226-8402
DOI: 10.7842/kigas.2016.20.2.1