Comparison and Analysis of Steel Frame Based on High Strength Column and Normal Strength Column
نویسندگان
چکیده
منابع مشابه
Fatigue Strength of Medial Column Plates
Introduction: The use of plate systems represents a well-recognized technique for obtaining an effective compression, reduction and stabilization of the medial column of the foot. In this study, the in vitro fatigue strength of NCM (Medial Column Fusion) plates was determined and compared to a competitor’s equivalent foot system. Material: Two plates were investigated: Stryker VariAx 2 NCM Plat...
متن کاملSlippage of Steel in High and Normal Strength Concrete
Composite action of any reinforced concrete member is only possible if sufficient bond strength exists between steel reinforcing bars and concrete, which can adequately transfer shear stress between them. Bond strength is a function of compressive strength of concrete and hence high strength concrete has higher bond strength [1-2]. Therefore required development length can be reduced. In order ...
متن کاملCyclic Evolution of Damage and Beam-column Interaction Strength of Concrete-filled Steel Tube Beam-columns
The assessment of response of composite seismic force resisting systems requires accurate nonlinear formulations for the composite members. In this work, reporting the first phase of a NEES project, a three-dimensional distributed plasticity formulation is presented for both circular and rectangular composite concrete-filled steel tubes (CFTs) that includes new constitutive models for the concr...
متن کاملEffect of column-foundation connection stiffness on seismic performance of rocking steel braced frame
Residual drifts after severe earthquakes interrupt serviceability of buildings. Retrofitting of such buildings is in many cases very difficult and consumes lots of time and money. Recently, there are some attempts to develop the seismic design procedures to not only satisfy life safety criteria but also lead to more economical buildings. One of these modern methods of improving seismic performa...
متن کاملBond of High Strength Concrete with High Strength Reinforcing Steel
This paper presents a study about the bond of high strength concrete with high strength steel. Fourteen pull out tests were carried out to determine the bond. The concrete strength was about 70 MPa and the steel was a 500 MPa grade. Bar diameters used were 12, 16, 20, 25, 28, 32 and 36 mm. In order to investigate the effect of cover, each test was done twice, once in a 240 mm diameter concrete ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Earth and Environmental Science
سال: 2018
ISSN: 1755-1307,1755-1315
DOI: 10.1088/1755-1315/108/2/022072