Complex fibers orientation distribution evaluation in short glass fiber-reinforced thermoplastic (PA66 GF50)
نویسندگان
چکیده
منابع مشابه
Simulation of Orientation in Injection Molding of a Highly Concentrated, Short Glass Fiber Thermoplastic Composites
This paper presents a 2D coupled Hele-Shaw flow approximation for predicting the flow-induced orientation of injection molded composite parts within a commercial concentration range. For a highly concentrated short glass fiber PBT suspension, the impact of inter-particle interactions and the orientation at the gate is investigated for a center-gated disk using a time-delayed orientation evoluti...
متن کاملWoven Glass Fiber-Reinforced
ment methods and two spec/imen diameters. Flexural strength and modulus of woven glass fiber-reinforced specimens werc significanLly greater than those without woven glass fiber (p<O.OD, Likewise, comprossive strength of reinforced specimens was signifieantly greater than those without woven glass fiber (p<O.Ol), except for specimens rcjnforced with woven glass fiber oriented at a tilt directio...
متن کاملProperties of agave fiber reinforced thermoplastic composites
Biocomposites have attracted a great deal of interest in research and industry sectors because they are typically lightweight, sustainable, environmentally friendly, and their thermomechanical properties can be designed to fit specific applications by tuning of their composition. In this study, mechanical properties of natural-fiber reinforced thermoplastic composite films were explored. Thermo...
متن کاملOverview of Flax Fiber Reinforced Thermoplastic Composites
Flax fibres are oftenly used for reinforcing thermoplastic to manufacture biocomposite materials exhibiting numerous advantages such as high mechanical properties, low density and biodegradability. The mechanical properties of a biocomposite material depends on the nature and orientation of the fibres, the nature of the matrix and mainly on the adhesion between fiber and the polymer matrix. The...
متن کاملFiber Orientation in Injection Molded Long Carbon Fiber Thermoplastic Composites
A set of edge-gated and center-gated plaques were injection molded with long carbon fiber-reinforced thermoplastic composites, and the fiber orientation was measured at different locations of the plaques. Autodesk Simulation Moldflow Insight (ASMI) software was used to simulate the injection molding of these plaques and to predict the fiber orientation, using the Anisotropic Rotary Diffusion an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC Web of Conferences
سال: 2018
ISSN: 2261-236X
DOI: 10.1051/matecconf/201816522026