Composite domain control for surface plasmon resonance

Fabrication and Characterization of the Fiber Optical Taper for a Surface Plasmon Resonance Sensor

For a fiber optical surface plasmon resonance (SPR) sensor a short part of its cladding should be removed to coat a thin layer of a metal. Usually this is problematic when an optical fiber with small core diameter is used. In this paper, a new method using µliter droplet of the HF acid for short fiber optical taper fabrication is reported. Using this method in a multi-mode optical fiber w...

Surface plasmon resonance biosensor

Imaging surface plasmon resonance

The central theme of this thesis is the use of imaging Surface Plasmon Resonance (iSPR) as a tool in the characterization of surfaces with laterally varying properties. Within the scope of this work, an instrument for iSPR analysis was designed and built. SPR is a very sensitive technique for monitoring changes in optical properties in the immediate vicinity of a sensor surface, which is very u...

Surface plasmon resonance

4. LIGAND 10 4.1. Direct versus indirect immobilisation 10 4.2. Covalent immobilisation 11 4.2.1. A general approach 11 4.2.2. Choice of chemistry 12 4.2.3. Prepare the protein 12 4.2.4. Pre-concentration 12 4.2.5. Amine coupling 14 4.2.6. Regeneration 15 4.2.7. Adjusting the immobilisation conditions. 16 4.3. Non-covalent immobilisation (ligand capture) 16 4.3.1. Using an existing strategy 17 ...

Surface Plasmon Resonance Sensors for Disease Diagnosis

Most of the optical sensors based on surface plasmon resonance (SPR) are imitated from two main configurations. Firstly, in the KretschmannRaether configuration, a thin metal layer is sandwiched between the prism and the air. Otherwise, the Otto configuration, there is a gap between the metal and the prism. However, the Kretschmann-Raether geometry is more conventional scheme to generate the su...