Composite Materials. Mixed Mode(I+II) Fracture Toughness and Rate Dependent Fracture Behavior of Interlayer-Toughened Composite Laminate.
نویسندگان
چکیده
منابع مشابه
Marginal fracture toughness of composite resins.
The marginal fracture toughness of several types of composite resins was determined by means of the rattler test. Microparticle-filled resins showed significantly higher marginal fracture toughness than conventional composites. Posterior restorative composites were intermediate between MFRs and conventional composites. Amalgams were inferior to restorative resins. These data correspond with the...
متن کاملFracture Problems in Composite Materials
In this paper a series of fracture problems in composite materials are identified, their methods of solution are briefly discussed, and some sample results are presented. The main problem of interest is the determination of the stress state in the neighborhood of localized imperfections such as cracks and inclusions which may exist in the composite. Particular emphasis is placed on the evaluati...
متن کاملPrediction of Mode II of Fracture Toughness in Laminate Composites
In this paper, effects of ply orientation of adjacent plies with (ϕ//θ) interfaces on mode II critical strain energy release rate (fracture toughness) of multidirectional (MD) laminate has been studied. Ply orientation of adjacent plies is one of the most important parameters affects the mode II critical strain energy release rate () in the initiation of the delamination. To study this paramet...
متن کاملFracture toughness of composite and unfilled restorative resins.
Fracture toughness, critical strain energy release rate, and critical stress intensity factor were determined for experimental and commercial restorative resins. A composite resin had lower resistance to crack initiation than an unfilled acrylic resin. The data were consistent with surface failure observed in single-pass wear studies of these resins.
متن کاملInterfacial Fracture Toughness Measurement and Improvement for Composite/metal Interfaces
Adhesive bonding is enlarging its application range as a practical method for the joining of dissimilar materials in automotives, aircrafts, microelectronics and medical devices industries replacing conventional joining techniques such as welding, bolting and riveting [1-5]. Especially for joining of fiber-reinforced polymer (FRP) composites to other structural materials such as metal, traditio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2001
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.50.482