Concentration of elemental ions released from non-precious dental casting alloys

The effect of hydrogen peroxide concentration on metal ion release from dental casting alloys.

There are concerns that tooth bleaching agents may adversely affect dental materials. The aim of this study was to test the hypothesis that increasing concentrations of hydrogen peroxide (HP) are more effective than water at increasing metal ion release from two typical dental casting alloys during bleaching. Discs (n = 28 for each alloy) were prepared by casting and heat treated to simulate a ...

Ingestion of Elemental Mercury Vapor Released from Amalgam Dental Fillings

Casting of Titanium Alloys for Dental Applications

In dentistry, gold-based noble metal alloys have traditionally been cast into various types of dental prostheses, such as partial dentures, crowns, and bridges. More recently, less expensive dental alloys with base-metal elements, such as Co-Cr and Ni-Cr, have been used. Titanium is considered to be an attractive alternative to these traditional dental alloys because of its remarkable lack of t...

Laser Welding of Titanium and Dental Precious Alloys

The performance of laser welding of Ti and two dental precious alloys (Ag-Pd-Au, Au-Pt-Ag) was investigated by mechanical testing and microscopic observation, using butt joint as design. The laser irradiation was done using a commercial Nd:YAG dental laser-welding device in a single pulse mode with output currents 150, 200, 250, 300A, spot diameters 0.6, 0.9, 1.2mm, and pulse duration 10ms. The...

Ions released from dental amalgams in contact with titanium.

The ions released from conventional and high-copper amalgams in contact with titanium were quantitatively analyzed in a 0.9% NaCl solution at 37 degrees C when the surface area ratio of titanium/amalgam was set up as 1/10, 1/1, or 10/1. The corrosion potentials of the amalgams and titanium were measured under the same conditions. Surface analyses on the amalgams were also employed using SEM wit...