Condensation / Evaporation Heat Transfer and Pressure Drop of R410A inside Aluminum Microfin Tubes

Condensation Heat Transfer of Pure Refrigerants in Microfin Tubes

Heat Transfer and Pressure Drop During HC-600a (Isobutane) Condensation Inside a Brazed Plate Heat Exchanger

This paper presents the heat transfer coefficients and the pressure drop measured during HC-600a (Isobutane) condensation inside a brazed plate heat exchanger: the effects of saturation temperature, refrigerant mass flux and vapour super-heating are investigated. The heat transfer coefficients show weak sensitivity to saturation temperature and great sensitivity to refrigerant mass flux. At low...

Condensation heat transfer and pressure drop in flat tubes having different aspect ratio

In this study, condensation heat transfer coefficients of R-410A were obtained in flattened stainless tubes made from 5.0 mm inner diameter round tubes. The test range covered saturation temperature 45 , heat flux 10 °C kW/m, mass flux 100~400 kg/ms and quality 0.2~0.8. Results showed the effect of aspect ratio on condensation heat transfer coefficient was dependent on the flow pattern. For ann...

Influence of Oil on Heat Transfer Characteristics of R410A Flow Boiling in Conventional and Small Size Microfin Tubes

In order to extend the existing heat transfer coefficient correlation of R410A-oil mixture flow boiling in conventional size (7.0 mm) microfin tube to be suitable for widely used small diameter tubes (4.0~5.0 mm), the experiments of R410A-oil mixture flow boiling inside three small diameter microfin tubes with different outside diameters of 4.0~5.0 mm and different microfin structures were perf...

Investigation of convective heat transfer, pressure drop and efficiency of ZnO/water nanofluid in alternating elliptical axis tubes

In this study, for the first time, the heat transfer and the pressure drop of zinc oxide nanoparticles in alternating elliptical axis (AEA) tube have been investigated experimentally. The zinc oxide nanoparticles were at volumetric concentrations 1% and 2%. The base fluid was heat transfer oil and the experiments were conducted at constant wall temperature. Also, the study was done in Reynolds ...