CONDITION BASED MONITORING OF ROTATING MACHINES USING PIEZOELECTRIC MATERIAL
نویسندگان
چکیده
منابع مشابه
Vibration Based Condition Monitoring in Rotating Machineries
In Chapters 15 and 16, the measurement and signal processing techniques, transducers, signal conditioners and signal analysis equipments are described, which are used in the rotating machinery condition monitoring. It is very important to display the measured signal in convenient form so as to be useful for the interpretation of the condition of rotating machinery. In the present chapter, by lo...
متن کاملLabVIEW based Condition Monitoring of Induction Machines
This paper focuses on experimental results to prove that motor current signature analysis (MCSA) can diagnose shorted turns in low voltage stator windings of 3-phase induction motors using LabVIEW. The diagnostic strategy is presented and variables that influence the diagnosis are discussed. Current spectra from motors with short-circuited turns (with and without short circuit current limiting ...
متن کاملRotating Machinery for Condition Monitoring
Novelty detection has been developed into a state-of-the-art technique to detect abnormal behavior and trigger alarm for in-field machine maintenance. With built-up models of normality, it has been widely applied to several situations with normal supervising dataset such as shaft rotating speed and component temperature available meanwhile in the absence of fault information. However, the resea...
متن کاملCondition Monitoring of Rotating Machinery using Active Magnetic Bearings
The concept that changes in the dynamic behaviour of a rotor could be used for general fault detection and monitoring is well established. Current methods rely on the response of the machine to unbalance excitation and are mainly based on pattern recognition approaches. However these methods are relatively insensitive and the crack must be large before it can be robustly detected. Active magnet...
متن کاملProposing a New Acoustic Emission Parameter for Bearing Condition Monitoring in Rotating Machines
Bearings are important machine parts and their condition is often critical to success of an operation or process, hence there is a great need for periodic knowledge of their performance. According to reported research works in the past several years, it is believed that the extracted information from acoustic emission (AE) signals can be used for bearing condition monitoring. In this work, a no...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Research in Engineering and Technology
سال: 2014
ISSN: 2321-7308,2319-1163
DOI: 10.15623/ijret.2014.0309047