Consolidation of Nanocrystalline Nd-Fe-B Powder by Hydrostatic Extrusion at High Temperature
نویسندگان
چکیده
منابع مشابه
Sintering of Nd-Fe-B Magnets from Dy Coated Powder
High-coercive (Nd,Dy)-Fe-B magnets were fabricated via dysprosium coating on Nd-Fe-B powder. The sputtering coating process of Nd–Fe–B powder yielded samples with densities greater than 98%. (Nd,Dy)2Fe14B phases may have effectively penetrated into the boundaries between neighboring Nd2Fe14B grains during the sputtering coating process, thereby forming a (Nd,Dy)2Fe14B phase at the grain boundar...
متن کاملStructural Evolution during Milling, Annealing, and Rapid Consolidation of Nanocrystalline Fe–10Cr–3Al Powder
Structural changes during the deformation-induced synthesis of nanocrystalline Fe-10Cr-3Al alloy powder via high-energy ball milling followed by annealing and rapid consolidation by spark plasma sintering were investigated. Reduction in crystallite size was observed during the synthesis, which was associated with the lattice expansion and rise in dislocation density, reflecting the generation o...
متن کاملProduction of fine Nd-Fe-B alloy powder by pulsed plasma atomization
Extremely fine (<10 μm) Nd-Fe-B powder was generated by pulsed plasma atomization processing. The number average was just over 3 μm, as determined by computer-assisted scanning electron microscopy analysis of almost 3000 particles. Despite the fine particle size, alloys of stoichiometric Nd2Fe14B resulted in the properitectic formation of -Fe, deleteriously affecting the magnetic properties. N...
متن کاملHigh-temperature giant magnetoimpedance in Fe-based nanocrystalline alloy
Giant magnetoimpedance ~GMI! was investigated from room temperature up to 823 K in an Fe-based nanocrystalline Fe73.0Cu1.0Nb2.5V1.0Si13.5B9.0 ribbon. With an increment of the measuring temperature ~T!, GMI shows notable enhancement followed by a declining dependence, yielding a maximum value around 603 K where the relative GMI is nearly four times that at room temperature. The field at the peak...
متن کاملImprove oxidation resistance at high temperature by nanocrystalline surface layer
An interesting change of scale sequence occurred during oxidation of nanocrystalline surface layer by means of a surface mechanical attrition treatment. The three-layer oxide structure from the surface towards the matrix is Fe3O4, spinel FeCr2O4 and corundum (Fe,Cr)2O3, which is different from the typical two-layer scale consisted of an Fe3O4 outer layer and an FeCr2O4 inner layer in convention...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Physica Polonica A
سال: 2017
ISSN: 0587-4246,1898-794X
DOI: 10.12693/aphyspola.131.1260