Contact stress analysis of disc cutter peg-hole with interference fit
نویسندگان
چکیده
منابع مشابه
Objective analysis of contact lens fit.
PURPOSE To assess the validity and repeatability of objective compared to subjective contact lens fit analysis. METHODS Thirty-five subjects (aged 22.0±3.0 years) wore two different soft contact lens designs. Four lens fit variables: centration, horizontal lag, post-blink movement in up-gaze and push-up recovery speed were assessed subjectively (four observers) and objectively from slit-lamp ...
متن کاملStress Analysis of Plate With Oblique Hole
13 Abstract-In this study, the wok is carried out to analyzed, the stresses of plate with oblique hole with the Finite Element Analysis. Stress analysis of a series of flat plates with oblique holes subjected to axial tension has been carried out using the finite element method (FEM). Different plate hole diameter-width ratios, angles of hole obliquity have been considered to provide stress c...
متن کاملExperimental Investigation and Numerical Prediction of Fatigue Life in Force Fitted Fastener Holes
In this paper, the effect of interference fit on fatigue life of holed plate of mechanical joints was investigated experimentally. Fatigue tests were carried out on the holed specimens of Al-alloy 7075-T6 alloy. The interference fit process consists of force fitting a fastener into the hole with a negative clearance (diameter of the fastener is larger than of the hole) that produces beneficial ...
متن کاملNumerical Analysis of Dynamic Response Mechanism of Rock by TBM Disc Cutter
The dynamic response mechanism of the rock fragmentation and its influential factors by TBM disc cutter are studied in this paper. Firstly, a dynamic response model is established based on the fracture mechanics and finite element theory. Secondly, a fragmentation rule is founded according to the dynamic response model, and then numerical simulations for dynamic response of rock are carried out...
متن کاملComplaint Manipulation for Peg-in-Hole: Is Passive Compliance a Key to the Contact Motion?
Peg in Hole has been extensively researched because it represents a contact task of manipulation that requires both position and force control. Most of the approaches assume a manipulator of serially connected rigid links, therefore, they highly depend on excellent resolution of a force/torque sensor that is normally very expensive and quite noisy, a precise model of a dynamic system, and a ver...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Canadian Society for Mechanical Engineering
سال: 2019
ISSN: 0315-8977
DOI: 10.1139/tcsme-2018-0130