Continuous Solidification of Si from Si-Al Melt under the Induction Heating
نویسندگان
چکیده
منابع مشابه
The Mechanical Strength of Si Foams in the Mushy Zone during Solidification of Al–Si Alloys
The mechanical strength of an Al-30% Si alloy in the mushy zone was estimated by using a novel centrifugation apparatus. In the apparatus, the alloy melt was partially solidified, forming a porous structure made of primary Si platelets (Si foam) while cooling. Subsequently, pressure generated by centrifugal force pushed the liquid phase out of the foam. The estimated mechanical strength of the ...
متن کاملDissolution and Precipitation Behaviour during Continuous Heating of Al–Mg–Si Alloys in a Wide Range of Heating Rates
In the present study, the dissolution and precipitation behaviour of four different aluminium alloys (EN AW-6005A, EN AW-6082, EN AW-6016, and EN AW-6181) in four different initial heat treatment conditions (T4, T6, overaged, and soft annealed) was investigated during heating in a wide dynamic range. Differential scanning calorimetry (DSC) was used to record heating curves between 20 and 600 °C...
متن کاملMICROELECTRONICS APPLICATIONS OF DEPOSITED Si FILMS RECRYSTALLIZED FROM THE MELT
Crystalline Si films on insulating substrates are needed for high-performance large scale integrated circuits, for high voltage devices, and for large area circuits used in flat-panel displays. Such films have been successfully formed by selective melting and recrystallization of polycrystalline Si deposited from the vapor on oxidized Si wafers and on bulk fused silica. Depending on the precurs...
متن کاملتشکیل فاز مولایت در فرایند اکسید شدن سیستم‌های Al2O3+Si، Al+Si و SiO2+Al
در این مقاله، اثر ترکیب مواد اولیه بر ویژگی?های فازی و ریزساختاری بدنه?های مولایتی بررسی شده است. سه سیستم SiO2+Al, Al2O3+Si و Al+Si با فرض اکسید شدن کامل عناصر Al و Si انتخاب شدند. مواد اولیه در محیط الکل اتیلیک توسط همزن مغناطیسی، مخلوط و پس از سپس خشک شدن، و گرانول? سازی شده و در گستره دمایی�C1600-700 حرارت دیدند. نتایج نشان می?دهد که در سیستم Al2O3+Si پس از دمای �C1450 فاز مولایت تشکیل می?ش...
متن کاملModelling of physical phenomena on Si melt during crystal growth process by Directional solidification method
Numerical simulation is a comprehensive tool in modern process development which is extensively used for promotion of crystal growth processes. Multi-crystalline silicon is an important material with advantages of low-production cost and high conversion efficiency of PV solar cells. The control of grains as well as the grain boundaries is particularly important to the crystal quality and thus t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2007
ISSN: 0915-1559,1347-5460
DOI: 10.2355/isijinternational.47.582