CONTROL OF PART SURFACE PARAMETER QUALITY DURING PROCESSING WITH SURFACE PLASTIC DEFORMATION
نویسندگان
چکیده
منابع مشابه
Vulnerability assessment of surface water quality with an innovative integrated multi-parameter water quality index (IMWQI)
The development of a surface water evaluation index is a critical factor in the assessment, restoration and protection of stream water quality. Quantifying water pollution in specific grade using dominant parameters is important, as this can explain the current state of water pollution with accuracy. As a result, an integrated multi-parameter water quality index has been developed. It is based ...
متن کاملVulnerability assessment of surface water quality with an innovative integrated multi-parameter water quality index (IMWQI)
The development of a surface water evaluation index is a critical factor in the assessment, restoration and protection of stream water quality. Quantifying water pollution in specific grade using dominant parameters is important, as this can explain the current state of water pollution with accuracy. As a result, an integrated multi-parameter water quality index has been developed. It is based ...
متن کاملcorrelation between twinning and surface rumpling phenomenon during plastic deformation of austenitic manganese steel
in this paper, the correlation between the surface rumpling and cracking phenomena with twinning mechanism during plastic deformation of hadfield steel has been investigated. the effect of stacking fault energy and the amount of strain are evaluated. the experimental samples with specific amounts of carbon, manganese and aluminum resulting in different stacking fault energies, were produced usi...
متن کاملFinite element analysis of elastic-plastic solids under Vickers indentation: surface deformation
Finite element modeling has been used to study the development of surface deformation during indentation with a Vickers indenter. A wide range of materials with different elastic modulus and yield stresses are examined. Results show that in a pyramidal indentation process, for a perfectly plastic material, sinking-in during loading can change to pile-up in unloading. This phenomenon depends on ...
متن کاملPLASTIC DEFORMATION BEHAVIOUR AT THE WORN SURFACE OF NOVEL CAST AL-ALLOY-TICP COMPOSITE
An AI-7wt%Si-5vol%TiCp was worn against a cast iron disc in a tri-pin-on-disc machine, under dry sliding conditions at the sliding speed of 0.24 m/s and applied loads of 6, 20 and 40 N/pin. Stress-strain (`3-^9) curves were constructed by measuring the microhardness and the equivalent strain gradients in near surface regions on the cross-sectional surface prepared parallel to sliding direction....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of Bryansk state technical university
سال: 2017
ISSN: 1999-8775
DOI: 10.12737/article_5a3779fb6455f6.47680401