Controling directionality of aluminium sheet
نویسندگان
چکیده
منابع مشابه
Aluminium fact sheet-April 03_e.DOC
Canadian Council of Ministers of the Environment, 2003 luminium (Al; CAS # 7429-90-5; molecular weight 26.98) is a silvery-white, pliable metal usually found in compounds as Al 3+ (WHO 1997). It is the most abundant metal in the earth’s crust, and the third most common element (Sparling and Lowe 1996). Aluminium is very light (density = 2.70 g·cm), capable of being hammered, cast, drawn out, ma...
متن کاملExperimental Study of Sable Crack Growth in Thin Aluminium Sheet
Recent failure information from research teams in NASA Langley and others has shown that CTOA based fracture models calibrated on large C(T) and M(T) specimens can be transferred successfully to cracked aircraft fuselage structures for the assessment of their residual strength. A major difficulty that could limit the more extensive use of this failure parameter is its experimental measurement e...
متن کاملWarm Deep Drawing of Aluminium Sheet
Aluminium sheet drawing processes can be improved by manipulating local flow behaviour by means of elevated temperatures and temperature gradients in the tooling. Forming tests showed that a substantial improvement is possible not only for 5xxx but also for 6xxx series alloys. Finite element method simulations can be a powerful tool for the design of warm forming processes and tooling. Their ac...
متن کاملAluminium sheet forming simulations: influence of the yield surface
The accuracy of simulations of the plastic deformation of sheet metal depend to a large extend on the description of the yield surface, the hardening and the friction. In this paper simulations of deep drawing of an AlMg alloy with a shell model are presented. The yield surface is described by a Von Mises, a Hill ’48 and a Vegter yield function. The parameters for the model are based on biaxial...
متن کاملFretting wear in self-piercing riveted aluminium alloy sheet
Fretting wear in aluminium alloy AA5754 joined by self-pierce riveting (SPR), a relatively new fastening technique increasingly used in vehicle structures, has been investigated in this paper. Surface damages have been induced when a joint experienced a sinusoidal cyclic tension-tension load. Various degradation zones have been characterised in the contact surfaces between the aluminium sheets,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1957
ISSN: 0451-5994
DOI: 10.2464/jilm.7.2_16