Conversion Coatings Matrix Composites for Aluminium Metal Matrix Composites
نویسندگان
چکیده
منابع مشابه
Basics of Metal Matrix Composites
Metal composite materials have found application in many areas of daily life for quite some time. Often it is not realized that the application makes use of composite materials. These materials are produced in situ from the conventional production and processing of metals. Here, the Dalmatian sword with its meander structure, which results from welding two types of steel by repeated forging, ca...
متن کاملBi-continuous metal matrix composites
Bi-continuous alumina/aluminium composites were made by infiltrating an alumina preform which had the structure of a reticulated ceramic foam. The low density preforms were prepared from a polyurethane suspension of alumina powder which was pyrolysed and sintered after foaming. Higher density preforms consisted of ceramic foams with open cells. All these preforms were infiltrated with 6061 alum...
متن کاملTribocorrosion in Metal Matrix Composites
One of the biggest motivations behind the development of the metal matrix composites (MMCs) is the improvement of the mechanical wear resistance of the unreinforced metallic matrix material mainly by the load-bearing effect of the hard reinforcement phases. However, in a large number of applications, MMCs are also required to operate in intimate contact with aqueous environments, which may lead...
متن کاملSynthesis of copper coated carbon nanotubes for aluminium matrix composites
In this investigation copper coated carbon nanotubes (CNTs) were prepared to enhance the interfacial bonding between CNTs and aluminum matrix by the molecular-level mixing process. In optimized plating bath of (1:1) by wt. CNT with Cu, thickness of coated CNTs is reduced to 100 nm to promote uniform distribution of Cu nanoparticle on the surface of pretreated CNTs. The mixing of CNTs was accomp...
متن کاملOptimization of MWCNT – Metal Matrix Composites feedstocks
Micro powder injection moulding-μPIM is a powder injection moulding-PIM variant for microparts/devices. This study is about the optimization and respective production of nanocomposites feedstocks suitable to μPIM process. The optimization of MWCNT content in metal matrix composites-MMC feedstock were performed using torque rheometry until achieve homogeneous feedstocks with suitable flowability...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Portugaliae Electrochimica Acta
سال: 2000
ISSN: 1647-1571
DOI: 10.4152/pea.200001013