Correction to: Mechanical properties of thermally evaporated germanium (Ge) and barium fluoride (BaF2) thin-films
نویسندگان
چکیده
منابع مشابه
architecture and engineering of nanoscale sculptured thin films and determination of their properties
چکیده ندارد.
15 صفحه اولThermal Annealing Influence over Optical Properties of Thermally Evaporated SnS/CdS Bilayer Thin Films
Thin films of tin sulfide/cadmium sulfide (SnS/CdS) were prepared bythermal evaporation method at room temperature on a glass substrate and then annealedat different temperature with the aim of optimizing the optical properties of the materialfor use in photovoltaic solar cell devices. The effect of annealing on optical propertiesof SnS/CdS film was studied in the temper...
متن کاملMechanical Properties of Evaporated Gold Films. Hard Substrate Effect Correction
Nanoindentation tests using the Berkovich indenter tip were performed on 50 and 200 nm thick polycrystalline gold films deposited on hard substrates. Gold film hardness increased with the indentation depth due to the influence of the substrate. A procedure based on the Joslin-Oliver method was introduced to correct for the substrate effect. The method utilizes the fact that the measured elastic...
متن کاملTunable Photoluminescence via Thermally Evaporated ZnS Ultra Thin Films
ZnS thin films have been deposited by thermal evaporation at various deposition rates. By controlling the deposition rate, the position of the maximum in the photoluminescence spectra could be easily tuned from 2.9 to 2.0 eV, which produced a corresponding change in the emission color. The optical and morphological characteristics of the ZnS thin films were measured. The photoluminescence spect...
متن کاملThickness dependence of the dielectric properties of thermally evaporated Sb2Te3 thin films
Sb2Te3 thin films of different thickness (23 350 nm) were prepared by thermal evaporation technique. The thickness dependence of the ac conductivity and dielectric properties of the Sb2Te3 films have been investigated in the frequency range 10 Hz100 kHz and within the temperature range 293373K. Both the dielectric constant ε1 and dielectric loss factor ε2 were found to depend on frequency, temp...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MRS Communications
سال: 2022
ISSN: ['2159-6867', '2159-6859']
DOI: https://doi.org/10.1557/s43579-022-00156-x