Correction to: Residual stress relaxation in HFMI-treated fillet welds after single overload peaks
نویسندگان
چکیده
منابع مشابه
Modelling Residual Stress and Phase Transformations in Steel Welds
Mathematical modelling of welding phenomena is very complex: involving melt pool phenomena, solidification, weldability analysis, microstructure evolution in the heat affected zone, welding heat-flow simulation, electrical-thermal-mechanical simulation etc. Some interactions between these processes are included in Fig. 1. Each topic alone can be intellectually challenging and too hard to be inv...
متن کاملResidual Stress Mapping in Welds using the Contour Method
The contour method, a newly-invented sectioning technique for residual stress measurement, has the potential to measure the cross-sectional residual stress profile of a weld in a simple and time-efficient manner. In this paper we demonstrate the capability of the contour method to measure cross-sectional residual stress profiles, which are compared with neutron diffraction measurements and show...
متن کاملUsing evolutionary algorithms to determine the residual stress profile across welds of age-hardenable aluminum alloys
This paper presents an evolutionary based method to obtain the un-stressed lattice spacing, d0, required to calculate the residual stress profile across a weld of an age-hardenable aluminum alloy, AA2024. Due to the age-hardening nature of this alloy, the d0 value depends on the heat treatment. In the case of welds, the heat treatment imposed by the welding operation differs significantly depen...
متن کاملDefect Detection and Residual Stress Measurement in Friction Stir Welds using Laser Ultrasonics
The laser-ultrasonic technique is proposed for defect detection and residual stress measurement in friction stir welds (FSW). When combined with the synthetic aperture focusing technique (F-SAFT), very good performances are achieved for detecting lack of penetration in butt joints, the detection limit coinciding with the conditions of reduced mechanical properties. Also, the detection of kissin...
متن کاملA Simplified Eigenstrain Approach for Determination of Sub-surface Triaxial Residual Stress in Welds
This paper discusses the localized eigenstrain method, a new technique for the determination of triaxial residual stresses deep within long welded joints. The technique follows from the “Inherent Strain Method” developed by Ueda, which uses a combined experimental and analytical approach to determine the source of residual stress (i.e., “eigenstrain” or, equivalently, “inherent strain”) by sect...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Welding in The World
سال: 2021
ISSN: ['0043-2288', '1878-6669']
DOI: https://doi.org/10.1007/s40194-021-01156-6