Corroded RC Beam Behavior Subjected to Random Loading in Various Pore Saturation Levels: Coupled Numerical Analysis

نویسندگان

چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Permittivity Variations on Marble Beams Subjected to Various Loading Levels

Marble beams were subjected to gradually increasing three-point bending from low loading levels up to levels that significant damage was observed. After each loading step the permittivity was measured at three characteristic locations: the tensional, middle and compressional zone of each sample. The permittivity measurements were conducted in the frequency range from 1kHz to 1MHz. The permittiv...

متن کامل

Numerical and Experimental Investigations on the Behavior of Steel-reinforced Concrete Columns Subjected to Eccentric Loading

Steel-reinforced concrete (SRC) columns, which are classified as composite columns, became the most widely used in recent years; because of their extensive advantages over the reinforced concrete and the steel columns. In this paper, the ductility index and its influential factors were explored to investigate the behavior of SRC columns. A straightforward approach was then proposed by establish...

متن کامل

Numerical Simulation of FRP-Jacketed RC Columns Subjected to Cyclic Loading

This paper presents a study that forms part of an ongoing project on the seismic retrofit of reinforced concrete (RC) structures with fibre-reinforced polymer (FRP). In this study, a stress-strain model for FRP-confined concrete subjected to cyclic loading was implemented into OpenSees to support the performance-based design of FRP jackets for the seismic retrofit of RC columns/structures. Init...

متن کامل

Numerical Analysis of Cyclic Behavior of Beam-To-Column Bolted Connections in Steel Frames

This article considers the seismic behavior of beam-to-column joints in steel frames for different bolt arrangements by using of finite element modeling. As the most important beam-to-column joint type, the beam-to-column joints with end-plate is chosen for the analysis. Four different specimens have been analyzed. These models had some differences such as bolt arrangement and the presence or a...

متن کامل

Time-Dependent Structural Behavior of Repaired Corroded RC Columns Located in a Marine Site

The chloride corrosion of reinforcing steel in reinforced concrete (RC) structures is a significant reason for premature deterioration and failure of RC structures in aggressive environments such as Persian Gulf region. This is one of the most important sources of engineering and economic problems in developed countries. So, the repair and maintenance of RC structures exposed to corrosive envir...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Annales De Chimie-science Des Materiaux

سال: 2022

ISSN: ['1958-5934', '0151-9107']

DOI: https://doi.org/10.18280/acsm.460402