Corrosion behaviour of amorphous Ti48Cu52, Ti50Cu50 and Ti60Ni40 alloys investigated by potentiodynamic polarization method
نویسندگان
چکیده
منابع مشابه
Corrosion Performance of Stainless Steel and Nickel Alloys in Aqueous Sodium Hydroxide as Revealed from Cyclic Voltammetry and Potentiodynamic Anodic Polarization
The electrochemical behavior of nickel, Inconel 600, Incoloy 800 and 316 stainless steel electrodes in different concentration of NaOH solution was investigated using the cyclic voltammetry technique (CV). All the curves in the anodic branch of the CV are characterized by anodic dissolution peak (A), passive region (B), anodic dissolution peak (C) before oxygen evolution. In the case of the cat...
متن کاملIn vitro corrosion behaviour of titanium alloys without vanadium
The corrosion behaviour of three new non-toxic titanium alloys for use as biomaterials has been investigated. The corrosion current densities of these Ti alloys have low values, indicating a passive state that is stable with time. These values were calculated by using both direct and alternate current methods. The comparison with Ti–6Al–4V, widely used as biomaterial, shows slightly lower corro...
متن کاملHigh pressure magnetic behaviour of amorphous YxNi1-x alloys
High pressure magnetization and Curie temperature measurements have been performed on several amorphous Y,Ni,-, alloys. The results seem to indicate that ferromagnetism disappears in a rather inhomogeneous way.
متن کامل[Dental alloys and corrosion].
Jedan od osnovnih zahteva koji se postavlja za sve stomatološke materijale jeste da su neškodljivi za ljudski organizam i (primum non nocere) i zatim da ne deluju nadražajno ili toksičko na oralna tkiva i organizam u celini. Oni takođe moraju biti niske alergijske aktivnosti i bez štetnog delovanja na bolesnike i osoblje koje njima rukuje. Stomatološke nadoknade ostaju u ustima dug vremenski pe...
متن کاملCorrosion of Metals and Alloys
Although all metals are subjected to the general oxidation reaction (I), the tendencies to ionize differ from metal to metal. When two metals are exposed to an aquenous environment and release electrons according to reaction (I) , an electric potential is induced the standard value of which can be measured when the metals are in 1-molar solutions of their own salts at a predetermined temperatur...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of Materials Science
سال: 2003
ISSN: 0250-4707,0973-7669
DOI: 10.1007/bf02704324