Crack and wear resistance increase at high-speed surfacing with low heat input
نویسندگان
چکیده
منابع مشابه
A Novel Very High Performance CMOS Current Mirror with extremely low input and ultra high output resistance
In this paper a novel very high performance current mirror is presented. It favorably benefits from such excellent parameters as: Ultra high output resistance (36.9GΩ), extremely low input resistance (0.0058Ω), low output (~0.18V) and low input voltage (~0.18V) operation, very low power consumption (20μW), very low offset current (1pA), ultra wide current dynamic range (150dB), and ultra high a...
متن کاملHigh-Speed and Low-Power Flash ADCs Encoder
This paper presents a high-speed, low-power and low area encoder for implementation of flash ADCs. Key technique for design of this encoder is performed by convert the conventional 1-of-N thermometer code to 2-of-M codes (M = ¾ N). The proposed encoder is composed from two-stage; in the first stage, thermometer code are converted to 2-of-M codes by used 2-input AND and 4-i...
متن کاملLow Complexity and High speed in Leading DCD ERLS Algorithm
Adaptive algorithms lead to adjust the system coefficients based on the measured data. This paper presents a dichotomous coordinate descent method to reduce the computational complexity and to improve the tracking ability based on the variable forgetting factor when there are a lot of changes in the system. Vedic mathematics is used to implement the multiplier and the divider in the VFF equatio...
متن کاملRadio Frequency-micro Electromechanical System Switch with High Speed and Low Actuated Voltage
This paper presents a novel RF MEMS (Micro Electromechanical System) fixed-fixed switch for very fast switching. Using the obtained equations, the switching time depends on the stiffness and effective mass of the switch beam so that the switching time will be decreased by higher stiffness (spring constant) and lower effective mass. In new design, the suspension bridge is a three-layer beam so t...
متن کاملHigh Efficient 3-input XOR for Low-Voltage Low-Power High- Speed Applications
A new 3-Input XOR gate based upon the pass transistor design methodology for lowvoltage, low-voltage high-speed applications is proposed. Five existed circuits are compared with the new proposed gate. It is shown that the proposed new circuit has at least 50% improvement in power-delay product than the CPL structure and than the CMOS structure. Moreover, the proposed new circuit could also be o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Reporter of the Priazovskyi State Technical University. Section: Technical sciences
سال: 2019
ISSN: 2519-271X,2225-6733
DOI: 10.31498/2225-6733.38.2019.181399