Cracking-assisted photolithography for mixed-scale patterning and nanofluidic applications
نویسندگان
چکیده
منابع مشابه
Reduction photolithography using microlens arrays: applications in gray scale photolithography.
This paper describes the application of reduction photolithography, using arrays of microlenses and gray scale masks, to generate arrays of micropatterns having multilevel and curved features in photoresist. This technique can fabricate, in a single exposure, three-dimensional microstructures (e.g., nonspherical microlens arrays) over areas of approximately 2 x 2 cm2. The simple optical configu...
متن کاملA combined-nanoimprint-and-photolithography patterning technique
We propose a new lithography technique that combines the advantages of nanoimprint lithography (NIL) and photolithography. In this combined-nanoimprint-and-photolithography (CNP) technique, we introduce a hybrid maskmold made from UV transparent material and with a light-blocking metal layer placed on top of the mold protrusions. We demonstrate that the CNP method using such a hybrid mold can a...
متن کاملCracking-assisted fabrication of nanoscale patterns for micro/nanotechnological applications.
Cracks are frequently observed in daily life, but they are rarely welcome and are considered as a material failure mode. Interestingly, cracks cause critical problems in various micro/nanofabrication processes such as colloidal assembly, thin film deposition, and even standard photolithography because they are hard to avoid or control. However, increasing attention has been given recently to co...
متن کاملInorganic polymer photoresist for direct ceramic patterning by photolithography.
A novel negative, inorganic polymer photoresist was demonstrated to be suitable for simple and direct fabrication of tribological SiCN-based ceramic microstructures via UV photolithography and subsequent pyrolysis at 800 degrees C.
متن کاملcarbon nanotubes for Electrospray nanofluidic Applications
Electrospray is the technique to soft-ionize liquids by applying a high electric potential to a liquid meniscus. The liquid meniscus is deformed into a cone [1], and charged species are emitted from its apex. The emission can be solvated ions, charged droplets, or a mix of the two. This low-divergence charged species source can be used in diverse applications such as mass spectrometry, propulsi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nature Communications
سال: 2015
ISSN: 2041-1723
DOI: 10.1038/ncomms7247