Crosspoint Localization of Spiral and Girth Welds of Spiral Steel Pipelines
نویسندگان
چکیده
منابع مشابه
A Vibration-Based Strategy for Health Monitoring of Offshore Pipelines' Girth-Welds
This study presents numerical simulations and experimental verification of a vibration-based damage detection technique. Health monitoring of a submerged pipe's girth-weld against an advancing notch is attempted. Piezoelectric transducers are bonded on the pipe for sensing or actuation purposes. Vibration of the pipe is excited by two means: (i) an impulsive force; (ii) using one of the piezoel...
متن کاملSpiral length design
On the circular curve, lateral acceleration affects comfort. On the spiral, both lateral acceleration and jerk affect comfort. The determination of maximum curving speed on the basis of lateral acceleration only is not critical because the lateral acceleration is proportional to the square of speed whereas jerk is proportional to cubic power of speed. The maximum speed on a curve is thus signi...
متن کاملFinite Element Modeling of Austenitic Stainless Steel Residual Stresses Pipe Girth Welds
Three-dimensional finite element modeling of residual stresses in a girth-welded pipe is presented in this paper, with an emphasis on modeling procedures for the global residual stress characteristics. The shell element model with a heat source moving along the circumferential joint is demonstrated to be cost effective and capable of predicting the global residual stress features. Transient res...
متن کاملParametric analysis of a broadband Archimedean spiral antenna with cavity
In this article an Archimedean spiral antenna is designed and analyzed that has good operation in broadband application. By analyzing this design, the effects that different parameters have on antenna operation will be studied and ways of optimization will be found. Influences of cavity height and number of turns to obtain good matching and gain in a frequency interval of 4 to 18 GHz will be d...
متن کاملStrong Ferritic – Steel Welds
There are many steels which are stronger than 2000 MPa, with toughness values exceeding 100 MPa m and which have been in commercial service for many decades. Examples include the marageing alloys and carbide–free bainitic steels. By contrast, welding consumables with a proof strength in excess of 1000 MPa are few and far between. This is because whereas wrought steels can be thermomechanically ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2020
ISSN: 2169-3536
DOI: 10.1109/access.2020.3020793