Crushed bricks as aggregate in cement based binder

Residual Mechanical Properties of Concrete Made with Crushed Clay Bricks and Roof Tiles Aggregate after Exposure to High Temperatures

This paper presents the residual mechanical properties of concrete made with crushed bricks and clay roof tile aggregates after exposure to high temperatures. One referent mixture and eight mixtures with different percentages of replacement of natural aggregate by crushed bricks and roof tiles are experimentally tested. The properties of the concrete were measured before and after exposure to 2...

MINIMUM CRUSHED AGGREGATE REQUIREMENTS FOR ASPHALT MIXTURES IN INDIANA Haiming

Used Of Recycled Tyre/Rubber as Course Aggregate and Stone Dust As Fine Aggregate in Cement Concrete Works

The present investigation aims at the study of properties of concrete in which stone dust is used as a partial replacement for coarse sand and tyre-chips of size 4.7 to 10 mm as partial replacement of coarse aggregate by weight.

Behaviour of Masonry Wall Constructed using Interlocking Soil Cement Bricks

According to the masonry standard the compressive strength is basically dependent on factors such as the mortar strength and the relative values of unit and mortar strength. However interlocking brick has none or less use of mortar. Therefore there is a need to investigate the behavior of masonry walls using interlocking bricks. In this study a series of tests have been conducted; physical prop...

Properties of Bricks Produced With Recycled Fine Aggregate

The main aim of this research is to study the possible use of recycled fine aggregate made from waste rubble wall to substitute partially for the natural sand used in the production of cement and sand bricks. The bricks specimens were prepared by using 100% natural sand; they were then replaced by recycled fine aggregate at 25, 50, 75, and 100% by weight of natural sand. A series of tests was c...