Crystal Structure of β-Aluminium-Magnesium Alloy
نویسندگان
چکیده
منابع مشابه
Crystal structure of a dimeric β-diketiminate magnesium complex
The solid-state structure of a dimeric β-diketiminate magnesium(II) complex is discussed. The compound, di-μ-iodido-bis-[(-{4-amino-1,5-bis-[2,6-bis-(propan-2-yl)phen-yl]pent-3-en-2-yl-idene}aza-nido-κ2N,N')magnesium(II)] toluene sesquisolvate, [Mg2(C29H41N2)2I2]·1.5C7H8, crystallizes as two independent mol-ecules, each with 2/m crystallographic site symmetry, located at Wyckoff sites 2c and 2d...
متن کاملPitting-induced hydrogen embrittlement of magnesium- aluminium alloy
In this study, the pitting corrosion susceptibility and its role on the hydrogen embrittlement behavior of AZ80 magnesium alloy were studied using slow strain rate testing (SSRT), electrochemical technique and immersion test method. The electrochemical and immersion tests in chloride-containing solution revealed severe pitting corrosion in the alloy. The SSRT results of the alloy under continuo...
متن کاملFracture Analysis of High Strain Rate Torsion Samples of Aluminium Zinc Magnesium Copper Alloy
All materials have been historically tested at static loading conditions. With the advent of technology, the study of behaviour of materials at high strain rate was done using various methods. The principle of split Hopkinson bar was used to study high strain rate of material in the range of 102s-1 to 103s-1. Split Hopkinson bars were designed for all three modes of deformation and extensively ...
متن کاملMagnesium borohydride: synthesis and crystal structure.
Figure 2. Raman spectra of Mg(BH(D)4)2 (in red) and LiBH(D)4 (in blue). Upper curves: deuteride, lower curves: hydride. The asterisk indicates a band resulting from residual diethyl-ether. Figure 5. Structure of Mg(BH4)2 viewed along the hexagonal b axis, showing two unit cells. Red (partially transparent) tetrahedra are BH4units; Mg atoms in blue. Considering the cations as A and the tetrahedr...
متن کاملPositron Lifetime Measurements of Subsurface Region in Aluminium Alloy and Aluminium Alloy Composite after Dry Sliding
This paper presents positron lifetime studies of the subsurface region of AK12 aluminium alloy and Al2O3-particle-reinforced AK12 aluminium alloy composite after sliding against steel in the pin-on-disc machine. The defect depth profile detected in the AK12 alloy extended up to 300 μm but for the composite AK12 the range of this profile was significantly shortened to less than ∼ 90 μm. The posi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nature
سال: 1944
ISSN: 0028-0836,1476-4687
DOI: 10.1038/154606a0