CTOD estimation procedure for clad pipe girth welds subjected to bending load
نویسندگان
چکیده
منابع مشابه
Finite Element Modeling of Austenitic Stainless Steel Residual Stresses Pipe Girth Welds
Three-dimensional finite element modeling of residual stresses in a girth-welded pipe is presented in this paper, with an emphasis on modeling procedures for the global residual stress characteristics. The shell element model with a heat source moving along the circumferential joint is demonstrated to be cost effective and capable of predicting the global residual stress features. Transient res...
متن کاملCurved arrays for improved horizontal sizing in small pipe welds
In the past, most small diameter pipe welds were radiographed for defects. However, radiography has significant limitations: safety and licensing issues, disruption to work schedules, chemical wastes, and poor detection of planar defects. Manual ultrasonics was permitted by some codes, but suffers from lack of recorded data and dependence on the operator’s skills. Automated ultrasonic testing (...
متن کاملCurved Arrays for Improved Inspection of Small Pipe Welds
This paper describes computer modeling and testing of phased arrays curved in the passive axis to improve focusing on small diameter pipe welds; in practice, a couple of curvatures satisfy most diameter and wall thickness applications. The modeling was followed by experimental testing using one of the curved arrays. Not surprisingly, the curved array showed significant improvements over a flat ...
متن کاملMoisture Content - Strength Relationship for Lumber Subjected to Bending *
Kennedy (1965) reported small clear strength values for most Canadian species. The average value for modulus of rupture for Douglas Fir based upon 1057 specimens was reported to be 7540 p. s. (52 026 kN/m2 ) when tested in the green (wet) condition while the average value for air-dried specimens adjusted to 12% moisture content was found to be 12,850 p.s.i. (88 665 kN/m2 ), an increase of 71%. ...
متن کاملEntropy Analysis in Pipe Flow Subjected to External Heating
In the present study, heat transfer and entropy analysis for flow through a pipe system is considered. The Reynolds number and the pipe wall temperature effects on entropy distribution and total entropy generation in the pipe are investigated. Numerical scheme employing a control volume approach is introduced when solving the governing equations. Steel is selected as pipe material, while water ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Structural Integrity
سال: 2016
ISSN: 2452-3216
DOI: 10.1016/j.prostr.2016.06.259