Cutting Forces, Chips Formation and Surface Roughness in Rock Cutting Using Negative Rake Angle

Multi Objective Optimization of Cutting Parameters in Turning Operation to Reduce Surface Roughness and Cutting Forces

Estimation of cutting forces and surface roughness for hard turning using neural networks

Metal cutting mechanics is quite complicated and it is very difficult to develop a comprehensive model which involves all cutting parameters affecting machining variables. In this study, machining variables such as cutting forces and surface roughness are measured during turning at different cutting parameters such as approaching angle, speed, feed and depth of cut. The data obtained by experim...

the effect of tool rake angle and cutting speed on cutting force during broaching process by using finite element modeling

0

Investigation of Cutting Forces Superalloy Inconel 718

Since the cutting tools used in machining process of super alloys are subjected to high cutting forces, accordingly tools life is reduced, therefore improvement in alloys machining and reducing cutting forces to achieve longer tools life is an essential necessity. In this research, the effect of changes in feed rate on cutting forces in machining process of nickel based super alloys is investig...

Effects of the Cutting Fluid Types and Cutting Parameters on Surface Roughness and Thrust Force

In this study, three different vegetable-based cutting fluids developed from raw and refined sunflower oil and two commercial types (vegetable and mineral based cutting oils), were carried out to determine for thrust force and surface roughness during drilling of AISI 304 austenitic stainless steel with HSSE tool. The uses of vegetable cutting oils was investigated in reducing thrust force and ...