Cutting stock problems and solution procedures
نویسندگان
چکیده
منابع مشابه
Cutting stock problems and solution procedures
This paper discusses some of the basic formulation issues and solution procedures for solving oneand twodimensional cutting stock problems. Linear programming, sequential heuristic and hybrid solution procedures are described. For two-dimensional cutting stock problems with rectangular shapes, we also propose an approach for solving large problems with limits on the number of times an ordered s...
متن کاملOne-dimensional Cutting Stock Problems and Solution Procedures
This paper provides an introduction to one-dimensional cutting stock problems and solution procedures. The first problem considered requires that both trim loss and pattern changes be controlled. Both linear programming and sequential heuristic procedures are discussed along with the ways they can be used jointly to generate the best possible solutions to this type of problem. Two other importa...
متن کاملAn Algorithm for Two Dimensional Cutting Stock Problems with Demand
In this paper, two-dimensional cutting stock problem with demand has been studied.In this problem, cutting of large rectangular sheets into specific small pieces should be carried out hence, the waste will be minimized. Solving this problem is important to decrease waste materials in any industry that requires cutting of sheets. In most previus studies, the demand of pieces has not been usually...
متن کاملAn Algorithm for Two Dimensional Cutting Stock Problems with Demand
In this paper, two-dimensional cutting stock problem with demand has been studied.In this problem, cutting of large rectangular sheets into specific small pieces should be carried out hence, the waste will be minimized. Solving this problem is important to decrease waste materials in any industry that requires cutting of sheets. In most previus studies, the demand of pieces has not been usually...
متن کاملPattern Minimisation in Cutting Stock Problems
In the cutting stock pattern minimisation problem, we wish to satisfy demand for various customer reels by cutting as few as possible jumbo reels, and further to minimise the number of distinct cutting patterns used. We focus on the special case in which any two customer reels t into a jumbo, but no three do: this case is of interest partly because it is the simplest case that is not trivial, a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: European Journal of Operational Research
سال: 1991
ISSN: 0377-2217
DOI: 10.1016/0377-2217(91)90293-5