DC Transmission Grid With Low-Speed Protection Using Mechanical DC Circuit Breakers
نویسندگان
چکیده
منابع مشابه
A Protection Circuit for DC-DC Converter with Voltage Doubler
This paper proposes a method to obtain a protected voltage gain by employing a protection circuit for the voltage doubler or multiplier circuit in an isolated tyde DC-DC Converter. The entire set up consists of a phase shift converter with a protected bridge/voltage doubler rectifier on the output side. The operating frequency of the phase shift converter is 20-25kHz (depending on the requireme...
متن کاملLow-Power CMOS Ramp Generator Circuit for DC-DC Converters
Ramp-signal generators are particularly critical in controlling the frequency and dutycycle of pulse-width modulated (PWM) switching supplies. They are normally implemented with a timed charging current source into a capacitor and a reset switch controlled by two comparators whose reference signals set the lower and upper limits of the ramp. A fast comparator is required to ensure the reset ope...
متن کاملMppt Controlled Dc-Dc Converter Using Passive Absorption Circuit
This paper introduces the use of the voltage multiplier technique and passive absorption circuit applied to the non-isolated dc-dc converter in order to obtain high efficiency and high voltage gain. A passive absorption circuit is inserted in the interleaved flyback converter to transfer the leakage energy to load. The operation principle of the circuit is explained. This paper also deals with ...
متن کاملDC Fault Protection in Shipboard Power Systems using Z-Source Breakers
DC faults may cause severe disruptions in continuity of service to vital loads in a shipboard integrated power system, hence detection, isolation and protection against dc faults must be incorporated in both medium-voltage dc and low-voltage dc systems. A standard z-source breaker can identify and de-energize a faulty dc load on both buses quickly. However, until now, provisions for re-energizi...
متن کاملA High Performance DC-DC Converter with Battery Charging Circuit
This paper introduces a bi-directional DC-DC converter with adaptive fuzzy logic controller (AFLC). Bi-directional power flow is obtained by the same power components and provides a simple, efficient, and galvanically isolated converter. In the presence of DC mains, the converter operates as buck converter, powers the down stream converter, and also charges the battery. When the DC mains fails,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Power Delivery
سال: 2015
ISSN: 0885-8977,1937-4208
DOI: 10.1109/tpwrd.2014.2371618