DEAD TIME MEASUREMENT BY TWO-SOURCE METHOD – OPTIMIZATION OF MEASUREMENT TIME DIVISION
نویسندگان
چکیده
منابع مشابه
Method for effective dead time measurement in counting systems
The counting losses introduced by the dead time of a counting system are a limiting factor in counting measurements. The purpose of this work is to report an efficient method for the measurement of the effective dead time of a counting system and to characterize its dead time behavior, providing a way to investigate each experimental situation. The method, which we designate as Delayed and Mixe...
متن کاملOptimization of Real Time PCR for Precise Measurement of HER2 Overexpression in Breast Cancer Specimens
Background: Breast cancer is one of the most prevalent malignancies among women in various countries. HER2 overexpression, which is due to different reasons, occurs in 20-30% of breast cancers. HER2 gene encodes an 185kDa transmembrane glycoprotein with 1255 amino acids. This active product triggers downstream intracellular signaling pathways inducing cell proliferation and cell survival. These...
متن کاملOptimization of measurement counting time in Gamma-ray spectrometry of soil samples
The method of optimal measurement counting time in Gamma spectrometry for soil samples was studied. Gamma spectrometry was done based on minimum detectable activity using the HPGe- p type with efficiency of 30% and FWHM 1.7keV (for 1.33 MeV 60Co). The samples were IAEA-RG Th-1, IAEA-RGU-1 and IAEA-RGK-1 prepared in bottles. The measurements were done for 12 different counting times from 5 min t...
متن کاملMeasurement and Prediction of Time-independent and Time-dependent Rheological Behavior of Waxy Crude Oil
Wax deposition phenomenon changes the rheological behavior of waxy crude oil completely. In the current work, the rheological time-dependent and time-independent behaviors of waxy crude oil samples are studied and flow curve and compliance function are measured for the oil samples with various wax contents at different temperatures. A decrease in temperature and an increase in wax content lead ...
متن کاملMeasurement of subpicosecond time intervals between two photons by interference.
A fourth-order interference technique has been used to measure the time intervals between two photons, and by implication the length of the photon wave packet, produced in the process of parametric down-conversion. The width of the time-interval distribution, which is largely determined by an interference filter, is found to be about 100 fs, with an accuracy that could, in principle, be less th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Informatics Control Measurement in Economy and Environment Protection
سال: 2018
ISSN: 2083-0157,2391-6761
DOI: 10.5604/01.3001.0011.6007