Decarburization of Na<SUB>2</SUB>CO<SUB>3</SUB> Pre-refined Hot Metal in LD Converter
نویسندگان
چکیده
منابع مشابه
The PredicTion of MeTal SloPPing in ld converTer on BaSe an acouSTic Signal
The negative influences of slopping in a BOF are pollution to the environment. They give lower yield and cause equipment damage. The prediction of these phenomena is based on information processing from the measuring microphone. The change of frequency in certain range is done by a signal for the prediction of slopping. In this paper two methods for prediction of slopping are described. The fir...
متن کاملInvestigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملFeed Forward Neural Network for Prediction of end Blow Oxygen in LD Converter Steel Making
A multi layered feed forward neural network model is being developed for the prediction of end blow oxygen in the LD converter using a two step process. In the first step intermediate stopping temperature is being predicted and using this as an input the end blow oxygen is predicted. In both the cases two hidden layers had given the best results compared to the single layer neural network. Inte...
متن کاملapplication and construction of carbon paste modified electrodes developed for determination of metal ions in some real samples
ساخت الکترودهاِی اصلاح شده ِیکِی از چالشهاِی همِیشگِی در دانش شیمِی بوِیژه شیمِی تجزیه مِی باشد ،که با در نظر گرفتن سادگِی ساخت، کاربردی بودن و ارزان بودن روش مِی توان به باارزش بودن چنِین سنسورهاِی پِی برد.آنچه که در ادامه آورده شده به ساخت و کاربرد الکترودهاِی اصلاح شده با استفاده از نانو ذرات در اندازه گِیرِی ولتامترِی آهن وکادمِیم اشاره دارد. کار اول اختصاص دارد به ساخت الکترود خمِیر کربن اصلاح شده با لِیگاند داِ...
15 صفحه اولInvestigation of fluid flow and heat transfer in tube hot metal gas forming process
In this study, hot metal gas forming process of AA6063aluminumtubeis studied with a focus on heat transfer of both fluid and solid phases numerically. An experimental study is simultaneously conducted to validate the numerical method. Some of the most important outputs of the present study, are velocity distribution of fluid inside the tube as well as the fluid in the gap between tube and matri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1983
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.69.6_611