Deflection Analysis of Micro Cantilever Due to Moisture Adsorption
نویسندگان
چکیده
منابع مشابه
Photothermal cantilever deflection spectroscopy
Microcantilever sensors offer high sensitivity in the detection of adsorbed molecules based either on resonance frequency shift or changes in cantilever deflection, as both of these signals can be detected with very high resolution. Despite the high sensitivity offered by this platform, cantilevers suffer from poor selectivity due to the lack of sufficiently selective interfacial layers which c...
متن کاملMEMS Capacitive Micro Thermometer Based on Tip Deflection of Bimetallic Cantilever Beam
Sensors & Transducers Journal (ISSN 1726-5479) is a peer review international journal published monthly online by International Frequency Sensor Association (IFSA). Available in electronic and CD-ROM. Abstract: Thermometry is an interested field in physics and metrology. In this paper, a capacitive micro thermometer based on the tip deflection of bimetallic cantilever beam was designed. The gov...
متن کاملLarge Deflection Static Analysis of a Cantilever Beam Subjected to a Point Load
This work presents geometrically non-linear static analysis of a cantilever beam subjected to a non-follower transversal point load at the free end of the beam. The material of the beam is assumed as isotropic and hyperelastic. In this study, finite element model of the beam is constructed by using total Lagrangian finite element model of two dimensional continua for a twelve-node quadratic ele...
متن کاملSiGeC Cantilever Micro Cooler
The fabrication and characterization of SiGeC cantilever microcoolers are described. Silicon on insulator (SOI) was used as the substrate, and two layers of 3 μm p-SiGe0.07C0.0075 and 1.14 μm n-SiGe0.07C0.0075 lattice matched to silicon were grown using molecular beam epitaxy. The uni couple cooler was fabricated using conventional integrated circuit (IC) processing, and the cantilever structur...
متن کاملAnalysis of Mass Based Micro Cantilever Using Comsol
--MEMS based mass sensors are being designed to identify the small amounts of materials especially for monitoring the food supply. The Fabrication of MEMS includes deposition of material layers, pattering by photolithography and etching to produce the required shapes, consequently leading to time taking and expensive method. In order to reduce the working time of sensor to market a Finite eleme...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Adhesion Society of Japan
سال: 2002
ISSN: 0916-4812,2187-4816
DOI: 10.11618/adhesion.38.169