Deflections of Composite Beams with Web Openings
نویسندگان
چکیده
منابع مشابه
Design of composite beams with web openings
ao"length of opening dh, dl"distance from top of steel section to centroid of concrete force at high and low moment ends of the opening, respectively dr"distance from outside edge of flange to centroid of reinforcement *b"maximum bending deflection for unperforated beam *m,b"maximum bending deflection for a member with an opening Fy"yield stress of steel FM y"reduced axial strength of steel in ...
متن کاملSteel Beams with Web Openings
The responsibility of a Structural Engineer lies in not merely designing the structure based on safety and serviceability considerations but he also has to consider the functional requirements based on the use to which the structure is intended. While designing a power plant structure or a multi-storeyed building, the traditional structural steel framing consists of beams and girders with solid...
متن کاملShear Strength of Reinforced Web Openings in Steel Beams
The floor beams of steel buildings, cold-formed steel floor joists in particular, often require large web openings, which may affect their shear capacities. A cost effective way to mitigate the detrimental effects of such openings is to weld/fasten reinforcements. A difficulty associated with an experimental investigation to establish suitable reinforcement schemes for openings in shear zone is...
متن کاملStrengthening of RC Slabs with Symmetric Openings Using GFRP Composite Beams
This paper describes the results of experimental testing of glass fiber reinforced plastic (GFRP) composite beam strengthened reinforced concrete (RC) slabs with two symmetrical openings. Specimens, one-half scale, have been designed and fabricated to reflect the most common RC bathroom slab used in school buildings. The specimen had dimensions of 2000 mm (width) × 150 mm (thickness) × 3000 mm ...
متن کاملTopology Optimization of Structures with Web-Openings
Abstract—Topology optimization technique utilizes constant element densities as design parameters. Finally, optimal distribution contours of the material densities between voids (0) and solids (1) in design domain represent the determination of topology. It means that regions with element density values become occupied by solids in design domain, while there are only void phases in regions wher...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Structural Engineering
سال: 1998
ISSN: 0733-9445,1943-541X
DOI: 10.1061/(asce)0733-9445(1998)124:10(1139)