Deformation and Fracture of Alumina Joints in Bending Creep
نویسندگان
چکیده
منابع مشابه
The Fracture Mechanics Concept of Creep and Creep/Fatigue Crack Growth in Life Assessment
There is an increasing need to assess the service life of components containing defect which operate at high temperature. This paper describes the current fracture mechanics concepts that are employed to predict cracking of engineering materials at high temperatures under static and cyclic loading. The relationship between these concepts and those of high temperature life assessment methods is ...
متن کاملCreep Deformation of Ice
Knowledge of the creep properties of ice often is needed in field and theoretical studies of the flow and deformation of glaciers, ice shelves, and ice sheets. Recently many of the icy moons in the solar system have become much better known as a result of the successful deep-space probe missions. An understanding of the physical processes that take place within them requires information about t...
متن کاملFlexural Properties and Fracture Behavior of Nanoporous Alumina film by Three-Point Bending Test
This study investigated the influence of porosity on the flexural property of a nanoporous alumina film. When the porosity of the alumina film increased, both bending strength and modulus declined. The results from the bending test revealed that the setting of the film during the bending test had significant influence on the flexural property. Fracture only occurred when the porous side of the ...
متن کاملCreep Deformation Measurement of 316H Stainless Steel Multi-pass Welded Joints using Digital Image Correlation
A high temperature measurement system for creep deformation based on the digital image correlation (DIC) technique is described. The new system is applied to study the behaviour of a multi-pass welded joint in a high temperature tensile test and a load controlled creep test at 545°C. Spatially resolved tensile properties and time dependent creep deformation properties across a thick section typ...
متن کاملFluctuations and scaling in creep deformation.
The spatial fluctuations of deformation are studied in the creep in Andrade's power law and the logarithmic phases, using paper samples. Measurements by the digital image correlation technique show that the relative strength of the strain rate fluctuations increases with time, in both creep regimes. In the Andrade creep phase characterized by a power-law decay of the strain rate ϵt∼t(-θ), with ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 2005
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.71.316