Deformation Mechanisms Operating in TWIP/TRIP Steels Processed by Warm to Hot Working
نویسندگان
چکیده
منابع مشابه
Influence of Initial Microstructure on Hot Deformation Behavior of Duplex Stainless Steels
In this research the effect of initial microstructure on hot deformation behavior in terms of Ferrite-to-Austenite ratios is studied. Two types of stainless steels C1 and C2 were homogenizing heat-treated and deformed under hot compression examinations at temperatures 900ºC and 1100ºC at strain rate of 0.1s-1. The results showed that the flow stress levels of specimens are strongly r...
متن کاملZinc based bioalloys processed by severe plastic deformation – A review
Zinc based alloys have recently attracted great attention as promising biodegradable metals. Zinc exhibits moderate degradation rates in biological fluid and the zinc releases during the degradation process is considered safe to human systems. However, these materials exhibit critical limitations in terms of mechanical properties for medical applications. Adding alloying elements as well as gra...
متن کاملeffect of ai on the hot deformation of ferrite in cu-mn steels.
effect of small al additions, from 0.14% to 0.31% ai, on the hot deformation behavior of low carbon steels containing 1%cu-1.2%mn was investigated in the temperature range of 750-800•c over the strain rate range of 1o.3.1o.1s•1 by a hot compression testing machine. the flow curves obtained, exhibited typical characteristics of dynamic recovery type of softening mechanism, and the critical strai...
متن کاملPrediction of Deformation Resistance of Low Carbon Steels during Hot Rolling
Phenomenological approach to the description of deformation resistance behaviour of steel and its microstructure development under the service hot rolling condition is still the most common useful and powerful. Utilising different experimental equipment such as torsion plastometer [1-5], compression plastometer [6-9], or advanced laboratory mills [10, 11] as well as different deformation techni...
متن کاملInfluence of Boron on Initial Austenite Grain Size and Hot Deformation Behavior of Boron Microalloyed Steels
The initial austenite grain size of boron microalloyed steel with three different amounts of boron (20, 40, and 60 ppm) was investigated under different heating temperatures (1150, 1100, and 1050 °C), and hot compression tests of samples in a wide range of temperature (900–1100 °C) and strain rate (0.1–10 s−1) were conducted. It was found that the initial austenite grain size increases with inc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Physica Polonica A
سال: 2018
ISSN: 1898-794X,0587-4246
DOI: 10.12693/aphyspola.134.640