Delamination Detection for CFRP Structure Using Electrical Resistance Change Due to Joule Heating
نویسندگان
چکیده
منابع مشابه
The Electrical Heating of a Conductor Due to the Joule-thomson Effect
Existence of a weak solution is established for the initial-boundary value problem for the system ff-iut-div(O(u)7u)+r(u)a(u)TuTv=a(u)]Tvl2,div(a(u)Vv)=O. The question of uniqueness is also considered in some special cases.
متن کاملNumerical analysis of the electrical failure of a metallic nanowire mesh due to Joule heating
To precisely examine the electrical failure behavior of a metallic nanowire mesh induced by Joule heating (i.e., melting), a previously developed numerical method was modified with regard to the maximum temperature in the mesh and the electrical resistivity of the nanowire. A sample case of an Ag nanowire mesh under specific working conditions was analyzed with highly accurate numerical results...
متن کاملFinal report Project Title: Wireless Damage Monitoring of Laminated CFRP composites using Electrical Resistance Change
It is difficult to detect delamination of rotating composite components like helicopter and wind turbine blades while in-service with a wired system. In the present study, a wireless system using a tiny oscillation circuit for detecting delamination of carbon/epoxy composites is proposed. In this system, a tiny oscillation circuit is attached to the composite component. When delamination of the...
متن کاملFuzzy Logic Based Delamination Detection in CFRP Panels
This paper presents an intelligent interpretation of ultrasonic C-scan results for carbon-fiber-reinforced plastic (CFRP) panels by using fuzzy logic approach. Ultrasonic C-scan results have relatively low resolution and poor imaging quality in anisotropic composites due to the speckle noise produced by the interference of backscattered signals. In this study, fuzzy logic was implemented to acc...
متن کاملMulti-spot Laser Scanning Thermography for Delamination Inspection GFRP Structure in CFRP/GFRP Structure
In this study, a multi-spot laser scanning thermography (MLST) system is developed for automated, rapid and long-range inspection of delamination in composite structures. First, thermal waves are generated by scanning a multi-spot laser beam over a target composite structure, and the corresponding thermal waves are measured by using an infrared (IR) camera. Then a thermal image processing algor...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 2008
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.74.1565