منابع مشابه
Microanalysis of copper-tin phases in dental amalgam.
An etch resistance phase was found in dental silver amalgam when the amalgam was examined metallographically. This phase was common to the silver alloy ingot as well as to its prepared amalgam. Qualitative electron microprobe technics were used to identify this phase. Quantitative electron microprobe analysis defined it as the R' phase of the copper-tin system or the intermetallic compound Cu6Sn5.
متن کاملWear of dental amalgam.
The wear of cental amalgam was studied by single- and double-pass sliding and by a silicon carbide abrasion test. A dispersed amalgam showed significantly better resistance to two-body abrasion than the spherical amalgams tested. The wear amalgam was determined by resistance to penetration and by a ductile mode of surface failure over the load range studied. Differences in the wear of amalgam a...
متن کاملMicrostructure of dental amalgam.
Numerous studies have been done in the past to identify the phases present in dental amalgam. Both metallographic and X-ray diffraction techniques have been used.-' Most researchers now presume that dental amalgam consists mainly of three phases. The original particle is an alloy of Ag, Sn, Cu, and sometimes Zn; the major portion is the compound Ag3Sn, which is often referred to as Py. After am...
متن کاملDental amalgam--environmental aspects.
Increasing knowledge about the risk of toxic effects caused by anthropogenic mercury accumulation in ecosystems has resulted in a growing pressure for reduction of the discharge of mercury waste. Consequently, the mercury waste problems of dental clinics have been given increased attention, and restrictions on handling and discharge of contaminated waste have been established in several countri...
متن کاملINVESTIGATING THE PHYSICAL AND MECHANICAL PROPERTIES OF HIGH-COPPER AND SILVER DENTAL-FILLING AMALGAM ALLOYS
Abstract: The aim of the present investigation is to study the physical and mechanical characteristics of dental-filling spherical high-copper and silver amalgams and to compare them with a common high-copper domestic unicompositional amalgam. In this study, cylindrical specimens were mechanically condensed according to the ISO 1559:1986 Standard in order to measure the compressive strength, Vi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Boston Medical and Surgical Journal
سال: 1886
ISSN: 0096-6762,1533-4406
DOI: 10.1056/nejm188602251140805