Design and Modelling of Different SRAM'S Based on CNTFET 32NM Technology
نویسندگان
چکیده
منابع مشابه
Design and modelling of different SRAM's based on CNTFET 32nm technology
Carbon nanotube field-effect transistor (CNTFET) refers to a field-effect transistor that utilizes a single carbon nanotube or an array of carbon nanotubes as the channel material instead of bulk silicon in the traditional MOSFET structure. Since it was first demonstrated in 1998, there have been tremendous developments in CNTFETs, which promise for an alternative material to replace silicon in...
متن کاملSRAM CELL BASED ON CNTFET AT 32nm TECHNOLOGY
The SRAM which functions as the cache for system-on-chip is vital in the electronic industry. Carbon Nanotube Field Effect Transistor (CNFET) is used for high performance, high stability and low-power circuit designs as an alternative material to silicon in recent years. Therefore Design of SRAM Cell based on CNTFET is important for Low-power cache memory. In cells, the bit-lines are the most p...
متن کاملDesign of Low-Leakage CNTFET SRAM Cell at 32nm Technology using Forced Stack Technique
As silicon semiconductor device feature size scales down to the nanometer range, planar bulk CMOS design and fabrication encounter significant challenges nowadays. Carbon Nanotube Field Effect Transistor (CNTFET) has been introduced for high stability, high performance and low power SRAM cell design as an alternative material. Technology scaling demands a decrease in both VDD and VT to sustain ...
متن کاملA New Low Power 9T SRAM Cell based on CNTFET at 32nm Technology Node
Abstarct---This paper proposes a new design of highly stable and low power SRAM cell using carbon nanotube FETs (CNTFETs) at 32nm technology node. As device physical gate length is reduced to below 65 nm, device non-idealities such as large parameter variations and exponential increase in leakage current make the I-V characteristics substantially different from traditional MOSFETs and become a ...
متن کاملDesign of a low power high speed 4-2 compressor using CNTFET 32nm technology for parallel multipliers
In this article a low power and low latency 4-2 compressor has been presented. By using modified truth table and Pass Transistor Logic (PTL) a novel structure has been proposed which outperforms previous designs from the frequency of operation view point. The proposed design method has reduced the total transistor count considerably which will lead to reduced power consumption and smaller activ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of VLSI Design & Communication Systems
سال: 2012
ISSN: 0976-1357
DOI: 10.5121/vlsic.2012.3106