Design and simulation of a simple laser rangefinder using a semiconductor optical amplifier-detector

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Design and simulation of a simple laser rangefinder using a semiconductor optical amplifier-detector.

Using numerical simulations, we show that cross-gain modulation between pairs of counter-propagating pulses within a semiconductor optical amplifier can be used to detect the range and reflectivity of a target, forming a compact time-of-flight laser ranger. The range is deduced from multiple contacts along the SOA. The SOA also provides gain to the optical pulses reflected off the target. A sin...

متن کامل

Design, Analysis and Simulation of a Linear Phase Distributed Amplifier

In this paper a new method for the design of a linear phase distributed amplifier in 180nm CMOS technology is presented. The method is based on analogy between transversal filters and distributed amplifiers topologies. In the proposed method the linearity of the phase at frequency range of 0-50 GHz is obtained by using proper weighting factors for each gain stage in cascaded amplifier topology....

متن کامل

dynamic analysis of semiconductor laser amplifier using transfer matrix method

transfer matrix method (tmm) has been applied to analyze characteristics of semiconductor laser optical amplifiers. the input signal is sinusoidal modulating wave and we do not assume the modulating bias signal as well. we have shown that the distoration arises from gain modulation at low modulation frequencies, but in microwave modulation frequencies, the gain takes an average value and the re...

متن کامل

Dual radioisotopes simultaneous SPECT of 99mTc-tetrofosmin and 123I-BMIPP using a semiconductor detector.

Objective(s): The energy resolution of a cadmium-zinc-telluride (CZT) solid-state semiconductor detector is about 5%, and is superior to the resolution of the conventional Anger type detector which is 10%. Also, the window width of the high-energy part and of the low-energy part of a photo peak window can be changed separately. In this study, we used a semiconductor detector and examined the ef...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Optics Express

سال: 2005

ISSN: 1094-4087

DOI: 10.1364/opex.13.003647