Design Charts of Lumped-constant Directional Coupler
نویسندگان
چکیده
منابع مشابه
Analysis and Design of a 3 dB Tunable Lumped-Element Directional Coupler
⎯An analysis of a 3 dB lumped-element directional coupler (LEDC) based on arbitrary terminal impedance is described numerically. To solve the conflicted requirement for broad bandwidth and small size in LEDC, a new structure of coupler is introduced, which can significantly improve bandwidth and whose size is only 3 cm×4 cm on the conditions of the frequency domain of 410 MHz to 490 MHz. The me...
متن کاملThe Design of half-subtractor Logic Function Based on Nonlinear Directional Coupler
In this paper a novel design of all-optical half-subtractor based on nonlinear directional coupler is proposed. By using four waveguides and appropriately adjusting the refractive indices and selecting the proper length of waveguides, halfsubtractor function can be obtained. The operation of this function is simulated by RSoft CAD-Layout (BeamPROP) simulator. The simulation results confirm the ...
متن کاملAnalysis and Design of an Ultra Wideband Directional Coupler
Abstract—In this paper, a novel wideband directional coupler using coplanar waveguide multilayer slot-coupled technique is presented and implemented. The coupler uses two coplanar waveguide lines etched on two layers and coupled through an hexagonal slot etched on the common ground plane located between these layers. Firstly, conformal mapping techniques were used to obtain analytic closed-form...
متن کاملDesign of a Liquid Crystal Tunable Directional Coupler
The accurate analysis of optical waveguides is an important issue when designing devices for optical communication purposes. Different numerical approaches exist for modeling waveguide structures and one of the most important issues is the calculation of the guided modes of the waveguide. Commercial programs are widely available for the analysis of isotropic waveguides or waveguides with a redu...
متن کاملDesign and manufacture of a directional coupler in LTCC
In this work, the design and fabrication process of a stripline 90 degree hybrid coupler using LTCC technology are presented. The main specifications required for the device developed were 1.03 GHz central operation frequency, isolation higher than 23dB and a maximum size of 15 mm x 10 mm. To obtain a starting point of physical parameters for the simplified DC configuration a transmission lines...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Institute of Television Engineers of Japan
سال: 1976
ISSN: 1884-9644
DOI: 10.3169/itej1954.30.482