Design, Fabrication, and Performance Characterization of LTCC-Based Capacitive Accelerometers
نویسندگان
چکیده
منابع مشابه
MEMS Capacitive Relative Humidity Sensor Design, Fabrication, and Characterization
The motivating principle behind this research is the development of a small, wearable sensor that would use humidity and temperature measurements as metrics for health monitoring. We have successfully fabricated macro-scale devices via pressing of a polymer between two aluminum plates, and the responses of these capacitors were tested in various humidity conditions. The transition from macro to...
متن کاملFabrication and Characterization of a New MEMS Capacitive Microphone using Perforated Diaphragm
In this paper, a novel single-chip MEMS capacitive microphone is presented. The novelties of this method relies on the moveable aluminum (Al) diaphragm positioned over the backplate electrode, where the diaphragm includes a plurality of holes to allow the air in the gap between the electrode and diaphragm to escape and thus reduce acoustical damping in the microphone. Spin-on-glass (SOG) was us...
متن کاملTemperature stabilization of CMOS capacitive accelerometers
CMOS micromachining technology allows the integration of micromachined structures defined by the fine-line geometry of the CMOS interconnect with circuits on the same chip. The mechanical structure is composed of the metal and oxide layers of the CMOS interconnect. One important consideration in design is the control of residual stress difference in the various layers that produce internal bend...
متن کاملMicro-gravity capacitive silicon-on-insulator accelerometers
In this paper, the implementation and characterization of high-sensitivity in-plane capacitive micro-gravity silicon-on-insulator (SOI) accelerometers with the readout circuitry are presented. The devices were implemented in 50 μm thick SOI substrates using a two-mask dry-release process. The fabricated accelerometers were interfaced to a low-noise low-power reference-capacitor-less switched-ca...
متن کاملFABRICATION AND CHARACTERIZATION OFHIGH PERFORMANCE CERAMIC MEMBRANE HAVINGNANOMETRE PORES
Abstract: In this study, carbon nanotubes (CNTs) were grown directly in the pores of micro porous pyrex membranesand consequently ceramic membranes with very fine pores and high porosity were achieved. Our experiment was donein two stages. Initially cobalt powder with different percent was homogeneously mixed with pyrex powder. In order toproduce row membranes, each of these mixtures were compa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Micromachines
سال: 2018
ISSN: 2072-666X
DOI: 10.3390/mi9030120