Design of a Piezoelectric-Actuated Microgripper With a Three-Stage Flexure-Based Amplification
نویسندگان
چکیده
منابع مشابه
A novel monolithic piezoelectric actuated flexure-mechanism based wire clamp for microelectronic device packaging.
A novel monolithic piezoelectric actuated wire clamp is presented in this paper to achieve fast, accurate, and robust microelectronic device packaging. The wire clamp has compact, flexure-based mechanical structure and light weight. To obtain large and robust jaw displacements and ensure parallel jaw grasping, a two-stage amplification composed of a homothetic bridge type mechanism and a parall...
متن کاملOptimal Design and Control of a z-Tilt Piezoelectric Based Nano-Scale Compensation Stage with Circular Flexure Hinges
The Taguchi method is widely used for the optimization of mechanical design and this study is used it in the design of a 2D circular flexure hinge for a z-tilt piezoelectric based nano-scale compensation stage. Maximum displacement of the stage is 16 μm at z-axis and ±30 arcsec at θx and θy. The most important design parameters for such a flexure hinge are minimal diameter, body height, and not...
متن کاملIntegral Sliding-mode Control of a Piezoelectric- Actuated Motion Stage
This paper presents the design of an integral sliding-mode controller for a piezoelectric-actuated system. The sliding-mode disturbance (uncertainty) estimation and compensation scheme is used. The nonlinear piezoelectric-actuated system is modeled as a first order linear model coupled with a hysteresis. When the model is identified, the hysteresis nonlinearity is linearized then the linear sys...
متن کاملPiezoelectric Microgripper Equipped with a Smart CMOS Camera
This paper deals with the design of a micro-eyein-hand architecture. It consists of a smart camera embedded on a gripper. The camera is a high speed (10 000 fps) CMOS sensor of 64 × 64 pixels. Each pixel measures 35 μm × 35 μm and includes a photodiode, an amplifier, two storage capacitors, and an analog arithmetic unit. The gripper consists of a 4 dof (degrees-of-freedom) (y+, y-, z+, z-) micr...
متن کاملOne-Dimensional design of a three-stage axial compressor with Its 3D numerical simulation
The purpose of this study is to design a three-stage axial compressor with identical pressure ratio which makes an adequate pressure ratio and efficiency in design point conditions with rotational velocity of 38000rpm and mass flow rate of 3.2kg/s. First of all, considering some restrictions such as Dehaller number more than 0.7 in all sections of the stator and the rotor, and relative Mach num...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE/ASME Transactions on Mechatronics
سال: 2015
ISSN: 1083-4435,1941-014X
DOI: 10.1109/tmech.2014.2368789