Design of an analog front-end for ambulatory biopotential measurement systems

Design of an Analog Front-end for Ambulatory Biopotential Measurement Systems

Fully Integrated Biopotential Acquisition Analog Front-End IC

A biopotential acquisition analog front-end (AFE) integrated circuit (IC) is presented. The biopotential AFE includes a capacitively coupled chopper instrumentation amplifier (CCIA) to achieve low input referred noise (IRN) and to block unwanted DC potential signals. A DC servo loop (DSL) is designed to minimize the offset voltage in the chopper amplifier and low frequency respiration artifacts...

Ambulatory Biopotential Measurement

AMBULATORY BIOPOTENTIAL MEASUREMENT by Lakshmi Chitra Penugonda Biopotential signals measure the electrical activity of different parts of the body. Conventional bedside monitors only provide information about the body under restricted conditions. Observation and documentation of biopotential signal during daily activities and the relation to patient symptoms may be important factors for clinic...

design of an analog fuzzy logic controller chip

fuzzy logic has been developed over the past three decades into a widely applied techinque in classification and control engineering. today fuzzy logic control is one of the most important applications of fuzzy set theory and specially fuzzy logic. there are two general approachs for using of fuzzy control, software and hardware. integrated circuits as a solution for hardware realization are us...

Analog Front-end Design for Wearable Ultrasound Systems

This project aims to provide a highly flexible platform for 3D ultrasound imaging. Figure 1 presents the system architecture. The CMUT device is flip-chip bonded to the supporting electronic circuits, which eliminates the cables. As a result, the channel count of the imaging system is increased, and the capacitive loading due to cables is greatly reduced. The transmitters in the system are reco...