Design of Low Voltage Signal Power for Lysing Cell
نویسندگان
چکیده
منابع مشابه
design of an analog ram (aram)chip with 10-bit resolution and low-power for signal processing in 0/5m cmos process
برای پردازش سیگنال آنالوگ در شبکه های عصبی ، معمولا نیاز به یک واحد حافظه آنالوگ احساس میشود که بدون احتیاج به a/d وd/a بتواند بطور قابل انعطاف و مطمئن اطلاعات آنالوگ را در خود ذخیره کند. این واحد حافظه باید دارای دقت کافی ، سرعت بالا ، توان تلفاتی کم و سایز کوچک باشد و همچنین اطلاعات را برای زمان کافی در خود نگهدارد. برای پیاده سازی سیستمی که همه این قابلیتها را در خود داشته باشد، کوشش...
15 صفحه اولDesign of A Low - Voltage and Low - Power Voltage Mode
A low-voltage and low-power voltage mode adder/subtractor using MOSFETs in weakinversion is presented in this paper. Since the MOSFETs in the proposed circuit are biased in weak inversion, consequently its power dissipation is very low. The proposed circuit has been simulated with the HSPICE using a N-well 0.35μm 2p4m process and the results show that, under the supply voltage of 1V, the power ...
متن کاملLow Power Low Voltage CMOS Mixed Signal Operational Amplifier
Abstract: This paper presents a new methodology for design of high speed CMOS operational amplifier in Sub-micron region. The opamp uses a compensation technique which increases the unity gain frequency and phase margin simultaneously. The CMOS op-amp presented in this paper works on 1.5V designed in 65nm standard CMOS technology. It exhibits 86dB DC gain. With load of 5pF, the unity gain frequ...
متن کاملA novel low-power full-adder cell for low voltage
This paper presents a novel low-power majority function-based 1-bit full adder that uses MOS capacitors (MOSCAP) in its structure. It can work reliably at low supply voltage. In this design, the timeconsuming XOR gates are eliminated. The circuits being studied are optimized for energy efficiency at 0.18-mm CMOS process technology. The adder cell is compared with seven widely used adders based ...
متن کاملDesign of A Low Power Low Voltage CMOS Opamp
In this paper a CMOS operational amplifier is presented which operates at 2V power supply and 1uA input bias current at 0.8 um technology using non conventional mode of operation of MOS transistors and whose input is depended on bias current. The unique behaviour of the MOS transistors in subthreshold region not only allows a designer to work at low input bias current but also at low voltage. W...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2011
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2011.08.264